Ademco - 100-110-1000-1003-1008-1009 Troubleshooting Guide

TROUBLE EXCESSIVE DRAIN OF PROTECTIVE CIRCUIT POWER SUPPLY OR REPEATED REPLACE OF PROTECTIVE CIRCUIT BATTERY also Part Section CAUSE Short and 6 of panel for protective wires Part Repair protective where wires around Short 1 sensitive and 6 on Replace Nos ohms ohms and 110 BELL SOUNDS WHENEVER KEY SWITCH TURNED TO ON OR NIGHT POSIT CAUSE Break protective sensitive Sticking and 6 on sensitive and 2 on Check protective Section Part ohmmeter ohms Visually burnish cure 316 and 317 BELL S RINGS BUT DOES NOT GIVE FULL SOUND also Part Section CAUSE Low bell power of a recharge hours without sure charge Replace operating Make changes bell Bell does not Section end of also CAUSE mounting caused bell binding Section bell for will avoid bell with bell necessary and 2 on coil Replace ohms corroded switch corroded and 2 of switch Clean 317 316 SYSTEM ARMED KEY AT ON OR NIGHT POSITION CIRCUIT also Part BROKEN Section DOES NOT OPERATE WHEN CAUSE protective entry each contact necessary power a discharged sure hours with shorted C bell and 2 on bell connections power of control bell and not 6 other operating wiring needed Part Section protective and 6 on control 316 and 317 corroded switch CAUSE bell Free or adjust CIRCUIT DOES NOT LATCH ON ALARM WHEN THE CONDITION CAUSING ALARM CORGECTED THE BELL STOPS EVEN THOUGH THE KEYSWITCH REMAINS OR NIGHT POSITION THE CAUSE and 2 on Clean 316 and 317 circuit and 2 on coil ohms with ohm circuit ohm coil ALARMS OCCUR DUR TO SWINGERS PROTECTIVE CIRCUIT Also Part CAUSE batteries during of to 4 ma current ma volts No equivalent Part for sure hours without defective Recharge A Packs corroded switch switch READING ON CONTROL PANEL SWITCH Controls CIRCUIT TEST POSITION ZERO OR LESS THAN 3 MILLIAMPS WHEN not apply Nos and CAUSE protected entry open Check all windows opened doors Close windows CAUSE battery protective no shorted sure operating output sure Recharae A Packs measure a volt screw wiring Part and Section to ohm open circuit with