Ademco - 1000 Series Control Notes

NOTES 0 N 1000 SERIES CONTROLS To eliminate wire wire for and 110 controls cut Open circuit circuit eliminate Nos wafer and 1020 control other no bell Series only Nos be paral and 4 No with controi hour and 4 The closing bell any of The addition one of I CAN BE USED WITH ANY 1000 SERIES CONTROL WITH ANY NO 221 OR 330 340 CONTROL see NOTE below stepped alarm when a mat ohm end of line mat TEST problem watt stepped using used causes drop out and armed No 603 method series completely necessary will and prevents sure rechargeable at meter add a voltage panel present cases where add an milliamps others may be necessary compensate mill cannot obtained meter power 6 battery series DO NOT use using Nos built in 2 CAN BE USED WITH ANY CONTROL IN THE 1000 SERIES WITH ANY NO 221 OR 330 340 CONTROL action above where volt meter cause mat directly Method mat act open circuit contact Method add an additional will be necessary used using power means of a Mat Coupler a closed voltage protective again may be 3 milliamp 3 CAN BE USED WITH ANY CONTROL THE APC SERIES CIRCUIT SUCH MAT CIRCUIT SUCH MAT couplers mat connected protective mat Part of manual To add sirens No panel an existing No 1.00 To add modularm an existing or 110 al I needed addltlon or 336 The bel test must be eliminated alarm above be used shunt an entry exit prevent alarm be eliminated central station module opening No or central a pre bell 355 will To add a telephone shunt No No relay oranentry exit be kept bell digital must be eliminated or existing described module entering can use a No relay 355 will note be used To eliminate Nos and 1004 controls Remove wired and place so Locate now visible wires Cut wlre the other when alarm will during of One wire other BELL TEST I