Ademco - 1007 Deluxe Control Instrument

No 1007 DELUXE CONTROL ENTRY EXIT DELAY 1 1007 1007 CONTAC Na 6 CELLS 492 or 497 RECklARGEABLE PbVVER SUPPLY BATTERIES I Circuit 492 or 497 or battery a 6 V DC shown POLAR 1 TY Sounding or a No AD 8 Bell 6 volt alarm ng dev i 2 amperes a No 5 I8 6 voI t number of open circuit momentary be wired paral No 219 Emergency Circuit POLARITY shown A single V DC be used power or 497 polarity polarity not observed not observed When testing Delay 60 seconds door set up will series will Always key control position obtalned When using a mat such as the Ademco No 158 without No 604 between as shown resistor needed mat coupler protective watf 500 ohm power supply used PROTECTIVE CIRCUIT WILL NOT SET UP WARNING LIGHT ON PANEL COMES ON CAUSE Weak end of l 3 volt Too much protective Open or short protective Using ohmmeter Replace batteries 3 volts Check higher pro ohms poor window protective for Section PANEL FUNCTIONS POORLY OR INTERMITTENTLY CAUSE Dirty damaged wafer ubr or corrosion No 317 spray with TV tuner PANEL DOES NOT OPERATE THE DELAY POS IT CAUSE Keyswitch been extreme Turn itch DELAY Key should BELL S RINGS BUT DOES NOT GIVE FULL SOUND also Part Section CAUSE Low bell in power of a rechargeable sure charge batteries without Replace low operating CAUSE changes in Bell does not Section end of note also mountina caused bell binding Short Section bell for Replace avoid bell with bell necessary corroded SYSTEM ARMED BELL DOES NOT OPERATE WHEN PROTECTIVE CIRCUIT Section also CAUSE protective entry each contact necessary are discharged power I ly charged bat sure Recharge A hours without power 2 of control volts bell not other operating bel Check and 4 on shorted Check wiring needed Part corroded Replace Bound bell Free or adjust lace WILL NOT RESET WHEN SYSTEM DISARMED CAUSE A short wlres panic and 6 of Use an ohmmeter circuit and 6 A tripped panic causing Reset FALSE ALARMS ACCUR DUE TO SWINGERS PROTECTIVE CIRCUIT also Part CAUSE Swinger Use No equivalent Part for Weak batteries alarm 6 volts I y i ng power and 2 Replace sure defective n Recharge A Packs I ly charged hours without Dirty corroded Replace STEPPING ON FLOOR MAT IF USED DOES NOT TRIP THE ALARM CAUSE Too much wires mat See See USING A SIREN HOWLER OR BLASTER iERE NO SOUND OUTPUT ON ALARM CAUSE device After devices