Ademco - 1014 & 1114 Troubleshooting Guide

TROUBLESHOOTING Nos 1014,1114 i TROUBLE DRAIN OF PROTECTIVE CIRCUIT POWER SUPPLY OR REPEATED REPLACE OF PROTECTIVE CIRCUIT BATTERY Section also CAUSE protective wires 3 and 4 of panel Section for pro Repair protective Check where wires around pinch bell I tage RINGS BUT DOES NOT GIVE FULL SOUND CAUSE power Replace mounting caused operating bell avoid bell binding or No 115 alarm module D module for with bell E necessary switch 5 of an ohmmeter excessive corroded wire Rxl other 4 of wire attach substantial ohmmeter of or shorted key SYSTEM ARMED BELL DOES NOT OPERATE WHEN PROTECTIVE CJRCUIT also Section BROKEN CAUSE contact protective entry Check each contact necessary batteries protective substantial batteries and pro measure batteries of voltage panel Check all wiring disconnects shorted i r and 7 of panel wiring bell bel clapper Free or adjust necessary clapper corroded CAUSE F TROUBLE Open wiring keyswitch defective 2 CAUSE F Any deviation a defective keyswitch BELL SOUNDS WHENEVER KEY SWITCH TURNED TO ON POSITION CAUSE protective defective poorly wiring Part Sect protec ohmmeter HI open circuit shorted closedi open and protective general Part Section de Check all 114 wires 9 of No now be armed without circuit wiring Part panel Section CIRCUIT DOES NOT LATCH ON ALARM WHEN THE CONDITION CAUSING ALARM CORRECTED THE BELL STOPS EVEN THOUGH THE KEYSWITCH REMAINS POSITION THE CAUSE or No Return ADEMCO for FALSE ALARMS OCCUR DUE TO SWINGERS PROTECTIVE CIRCUIT also Part Section CAUSE Use No equivalent Part for batteries of separate defective ON FLOOR MAT IF USED DOES NOT TRIP THE ALARM CAUSE much wires Series Series USING A STROBE LIGHT AS AN ALARM WHEN ACT I VATED LIGHT FAILS TO CAUSE Polarity strobe of positive attach panel wire negative strobe battery operating volts TROUBLESHOOTINGN I C WITH SYSTEM ARMED BELL DOES NOT SOUND WHEN OPEN CIRCUIT IS CLOSED CAUSE Defective short Replace ohmmeter ver Break wire open circuit Repair necessary ON ALARM BELL DOES NOT CUT OFF AFTER MINUTES JUMPER WIRE UNCUT CAUSE Defective Return module ADEMCO for AUTOMATIC RESTORE FEATURE NOT WORKING PROPERLY RED AND GREEN CAUSE Defective No Return ADEMCO for I I5 module open circuit I I5 module UNCUT