Ademco - 1020 & 1006 Troubleshooting Guide

NG No lb20 AND 1006 DRAIN OF PROTECTIVE CIRCUIT POWER SUPPLY OR REPEATED RE OF PROTECTIVE CIRCUIT BATTERY also Part Section CAUSE and B and wires and 6 wires protective s C and D protective Part Sect H Repair where wires les or around sensitive Part Section When using shown and 3 on Diagram DO NOT When using black common power shown and 3 Diagrams and C OR OTHER SOUNDING DEVICES DO NOT GIVE FULL SOUND CAUSE power of a rechargeable bell in hours wlthout sure charge es operating end of does not Section also wiring mounting caused bell binding Section bell for Part avoid bell will with bell CAUSE Short and 2 on coil 1 Coil ohms measure Replace ohms Dirty corroded Replace Dirty corroded contacts and 2 of Clean with 317 316 BELL CIRCUIT DOES NOT CORRECTED THE BEL POSITION ON ALARM WHEN THE CONDITION CAUSING ALARM STOPS EVEN THOUGH THE KEYSWITCH REMAINS THE CAUSE Dirty on and Clean 316 and 317 Open circuit and 2 on coil ohms with ohm Replace ohm coil open circuit WITH SYSTEM ARMED KEY NIGHT POSITION DOES NOT OPERATE WHEN CIRCUIT BROKEN also Part SectionHI CAUSE Stuck protective entry Check each contact necessary Disconnected discharged power are sure Recharge A I ly charged hours without Check connections power 4 of control volts bell not other bell Disconnected bell and 2 on shorted C Check wiring repair needed Part CAUS E protective and 6 on control and 317 corroded c bell or adjust necessary clapper FALSE ALARMS OCCUR DUE TO SWINGERS PROTECTIVE CIRCUIT also Section CAUSE pro Use No equivalent Part for batteries pdtier 4 ma current ma during of volts defective Recharge A Packs hours without voltmeter sure used measure corroded READING ON CONTROL PANEL ALL POSITIONS OF THE KEYSWITCH EXCEPT BELL TEST CELLS USED WITH RECHARGE A PACK TO POWER PROTECTIVE ClRCUlT PROTECTIVE CIRCUIT 0 MILLlAMPS OR LESS THAN 3 MILLIAMPS READING WITH APPROXIMATELY 3 4 MA NORMAL APPROXIMATELY 6 MA DO NOT USE A RECHARGE NO 1006 CONTROL CAUSE protected entry open alI windows and NIGHT protective doors dOQrS windows batteries operation volts no shorted sure CAUSE Weak Recharge A Pack wlthout Recharge A Pack charged NOT power control No A break short protective Repair Be sure Recharge A Packs a voltmeter operating output measure wiring and B and and D