Ademco - 1022 & 1022-12 Troubleshooting Guide

TROUBLESHOOTING Nos 1022 AND 102242 SYSTEM APPEARS TO HAVE NO POWER CAUSE AC power disconnected LEDs as well when below a discharged a bell de BELL TEST switch a Part Be sure active No at AC outlet hours e ce I Is are sure panel socket No 1022 dead battery volts BELL Replace PROBABLE CAUSE No 496 of No 1022 12 Highly black switch of No capable being protective through pane by disconnecting I wires all other and 14 and and 25 charge properly hours manner green hours bell other 496 I 2 circumstances ma auxiliary attached device of and consulting described hours without acid prolonged be put on a 24 hour Part Sections a highly batteries on 2 and 3 DO NOT leave more 3 acid 6 months 4 not operate No or without battery work and some problems occur bell ZONE STATUS LED s AT ALL TIMES CAUSE A point entry protective open ground a break Take corrective Part Section Remove wires and 2 24 Hour Zone particular Entry Exit and 6 2 Zone 8 and 9 for opening and of all Series 1000 ohm resistor 606 shorted proper of No 1022 12 Series 2000 ohm resistor 607 and 8 can jumper on panel out protective remains Part D below The B wires as bescri not meet above With and 1500 ohms ohms proper should Series ohmmeter problem Part A Section pro between and of No 1022 12 no greater Series ohms Section measured breaks outlined described Dead or discharged Parts are dimly and B it TROUBLE Part B I ace battery TROUBLE Problems The I tamper must be overi id open circuit panel with which wired override GREEN LED ON PANEL LIT MORE BRIGHTLY THAN NORMAL CAUSE Disconnected Reconnect molded panel and black securely end of SOUNDS WHENEVER KEYSWITCH PLACED THE NIGHT POSITION CAUSE breaks brotective a short wi res not meet specifi a an alarm armed TROUBLE 2 and B TROUBLE 2 Parts Troubleshooting Part manual and B Section Unit must be returned SERIES 24 LED LIT ACCOMPANIED BY BUZZER SOUNDING CAUSE grounded DAY ZONE panel ohmmeter Troubleshoot manual ZONE protective guidelines Section Part of open wires 9 with 2500 ohms wired ohms of No ohmmeter a very DAY ZONE when using No a UL prescribed AB bell continuity bell see cover ohmmeter describer Part A above very an open circuit faulty ohmmeter outer short