Ademco - 1026, 1028, 1030 Troubleshooting Guide

TROUBLESHOOTING Nos 1026 IO28,1030 SYSTEM APPEARS TO HAVE NO POWER NOS AND 1028 ONLY CAUSE AC power well TEST switch a bell a discharged depressed a dead battery Part at AC outlet hours Be sure active with PROBABLE CAUSE B negative positive sure Highly and 20 dead battery volts proper TEST determine being Replace PROBABLE Remove protective wiring by disconnecting of No Remove all mini howler other Allow charge properly hours manner green hours other not be brought No 597 SYSTEM APPEARS TO HAVE NO POWER NO ONLY CAUSE power measure volts a dead or Be sure active black at AC outlet sure hours volt pro ON NO ON 026 STATUS L EDs LIT AT ALL AiiMING STATIONS CjR ilGi i IMES ACCOMPAN I E J BY EXT SHED IF USED CAUSE A point entry open more wires attach jumper a break ohms protective Take Part proper Section Part and 4 and another and 3 attach and 6 third out on panel protective remains Part C be low according Section The maximum allowable measure each and 4 and 3 5 and 6 ohms Part Section 300 ohms Use an any measures Dead or discharged are dimly panel Parts and 8 Recharge per Part A Problems control Return ZONE STATUS LED LIT AT ALL TIMES AND 1030 CAUSE point zone entry open more a break ohms wires protective 4 attach jumper and 6 attach goes out protective re between second and 5 rema i ns on Part B be low I Take Part proper Section The maximum allowable measure and 6 and ohms each 300 ohms Use an and 5 Part Section any Problems control Return GREEN PANEL LED LIT MORE BRIGHTLY NORMAL NOS 1026 AND 1028 CAUSE Disconnected Reconnect going going wire with BELL SOUNDS WHENEVER SYSTEM ARMED CAUSE LED to protective short oops more ohms TROUBLE 3 Part A No TROUBLE 4 Part A Nos 1030 relay Unit must be BELL TEST BELL OR OTHER SOUNDING DEVICE OPERATES BUT FULL SOUND NOT CAUSE battery B of power and 1028 TROUBLE sure AC transformer 24 hour outlet No indication panel TROUBLE plugged panel volt Part B standby volt needed bell GI not conform a I so Part speci end Sec mounting caused bell binding so bell dot on dome Section bell Part for Replace avoid bell CAUSE with bell corroded Unit must be using blaster electronic particular modules SYSTEM ARMED BELL OR OTHER SOUNDING ZONE OPENED DOES NOT OPERATE WHEN CAUSE bell sure device s no more are pro and 16 with No 90 12 No 90 2 No 1030 blow Part below broken wires