Ademco - 359 Self Restoring Bell Cut-Off & Power Supply

No 359 SELF RESTORING BELL POWER SUPPLY 605 RESISTORS ohms 10 watt Schedule below cut off CONNECTIONS 1000,1003 1005 Controls No 100 CONNECTIONS applicable above APPLICATIONS 1020 Nos 1000 controls I I vary A AML APL ARL 12 V AC TRANSFORMER No 1320 After hour outlet be power BELL POWER INPUT TERMINALS of control draw BELL CUT OFF ADJUSTMENT add enclosed parallel 605 above set cut off amperes ohm resistors and 2 of CUT OFF TIME I NALS 3 4 RES I STORS RESISTOR RESISTORS BELL BELLS U L REQUIRES BEL L TO RING FOR AT LEAST 30 MINUTES I NA LS 5 6 No 90 6 I STOR No 605 CIRCUIT ma at 6 Volts ma at 4 V amp when pack not use ohms watt RAT I NG 1.2 ampere hours OUTPUT FROM POWER SUPPLY CAUSE and 497 of 97 Replace with 90 6 ampere Unit must be returned circuit of Nos will I Unit must be returned PERFORMACE NOT OBTAINED FROM UNIT CAUSE sure input an active hour unswitched storage unit sure plug each 6 monthsof acid Nos 492 and 493 must hours operated maximum out on devices not exceed each power each unit permanently ones Only of Nos 492 and 493 drawn adaptors used only unit power protective extra detectors alarm power prolonged be put on 24 hour sealed acid hours without a batteries NOT BELL RINGING APPLICATIONS OFF AT THE PREDETERMINED TIME DOES NOT RING LOUDLY ENOUGH OR DOES NOT THE CASE OF NOS 358 AND 359 CAUSE unit be a 24 hour outlet sure day being hours be a non switched Defective unit i stors ma rching