Ademco - 404 Transmitter

No 404 TRANSMITTER No 404 non superv rounds whenever end of sed oop hold up sent hold up used and any break or activated hold up also the be operated STRIP AT LEFT TERMINAL STRIP LINE IN LINE OU red and block to 6 volt battery power motor Polarity be observed1 r COD VaILI I1CHT Itl t CODE Up CIRCUIT TERMINALS 3 8 4 HOLD UP CIRCUIT supervise of closed 2661 wired built in series energize hold up be used voIts are 268 or TERMINALS 5 8 6 number of open circuit not ine supervision HOLD UP CIRCUIT underside parallel must be used black be used non supervised not non white wires be reversed be used 266 and 268 hold up non supervised POWER SUPPLY 6 volts devices No 866 Battery motor Ademco No 96 Rechargeable Supply with specifically No 96 Power Supply will well No 96 will also protective used hours motor supervised be observed motor will CUT CODE WHEEL Place sharp placing wil not use cutting chisel result nylon Code Wheel a sharpened of chisel up cut of cut a wood wheel a sloppy LOCK CODE WHEEL ON MOTOR HUB AFTER CUTTING CODE Adjust awaiting when Wheel do not engage on McCulloh Transmitter Code NO 404 THE DESIRED PROGRAMMING CGDE IS NOT CORRECTLY SENT DURING THE TRANSMISSION CAUSE The codinq been proqrammed carelessly Follow procedures cut wheel with base of The excessive Replace wheel brush with Line Brush Nos Code and 395 Be sure i ri nq has been per d Faulty across panel proper volt voltage fault Refer The brush become Clean old Polarity and black Be sure and attach RED flying s HOLD UP DEVICES ATTACHED TO TERMINALS 5 AND 6 DO NOT ACTIVATE THE TRANSMITTER CAUSE Broken disconnected Failure black underside Check wiring needed Reverse