Ademco - 413-418 Digital Transmitters

INFORMATION Nos and 418 Digital and are U L devices supervised designed Grade A Central a central Local be The Nos and 418 differ with No 418 motion motors completely al arm codes are easi printed no code wheels programmed arrang of easily McCulloh on WIRE WIRE 1 2 3 I CODf 2 3 4 4 CODE WIRE WIRE 3 2 3 CODE wires wires by using by using code wire 3 4 4 code consists a code attached brown orange used set means of spade i ns are designated to 9 from orange wire wi re alarm each w i re shows how a 2 3 l by using i rst wire printed number be attached any one pin wire necessary number being pin being which shows how set set in column numbers as 2 4 2 connected 3 3 3 also orange wire which programmed at bottom shows how a 2 3 code set PROCEDURES SET on unplugged out closed and off calx alarm A C should out checked make sure alarm operating plugged standby electrica called A C being V AC Set Transmitter Closing With entire out doors OFF make sure SET be turned BELL TEST SET ARM positions ON skipping BELL TEST order properly exit pause a moment at each BELL TEST battery bell ARM The bell an attempt made ARM and ON positions set when will protective be set advanced exit ON now set and send transmitted round will close close 1 the exit exit door No 413 exit aware closed exit premises round opened and a second will be sent transmiited central round DELAYED exit seconds way out protective end of centrat delay closed exit ringing end of No 418 ON pass end of premises No 418 number of delay closed at occurred protective will not closed exit opening closing at will sent brotective been no opening closing protective exit subsequently way exit rounds will will a three will a ONE round exit THE RED JUMPER which exit desired provided exit either exi No 413 or 418 and 8 wi I I NOT be transmitted exit closed Rounds For Alarm three exit alarm or window or any other OFF will bell will transmitted protective OFF during will opening any protected end