Ademco - 4190U Universal 2-Zone Remote Point Module

Several of you have written us to ask that we reconsider this decision We have Tech Man Subscriber apologizes for any misunderstanding that has arisen due to our recent to have our technical information removed from the Tech Man web site You appreciate that one of our key concerns is to provide installing security dealers with and accurate information on our products and we were concerned about the data to the Tech Man web site For obvious reasons we also do not wish unauthorized to have access to information on installing and configuring ADEMCO These concerns were what prompted us to ask Tech Man to stop posting installation instructions and user manuals will not require Tech Man to remove the ADEMCO data ADEMCO however is responsible for the operation and maintenance of this site thus we cannot guarantee timeliness or accuracy of the information posted on the Tech Man web site data about our products You may request a PIN number for access to the Technical Support web site and FAXBACK system you need assistance on troubleshooting or if you have other technical questions our products not addressed in the information posted at our web site please contact Technical Support at 800 645 7492 ADEMCO web site is located at www ademco com and contains accurate you for understanding Lustig INSTRUCTIONS 4 97 Two Zone Point Module APPLIES TO ZONE LOOP 1 for fast response for use with no EOLR only Doing automatically puts an 10K ohm resistor in with the zone CUT Use the 10K ohm resistor with switches in an open circuit or configuration draws 2 mA from the loop in this mode Notes right loop may not be used for Com Fire or UL Commercial Burglary For Commercial Fire usage Use N O con on the left loop Supervise style B loop using Model 610 11 Fire Listed ohm EOLR purchased separately as of the 4100 EOLR resistor kit For UL Commercial Burglary Usage Use or N C contacts on the left loop using the 10k ohm EOLR sup 2 1 8 53mm 3 1 4 81mm 1 25mm Input 8 11VDC Drain 2mA Information ADEMCO 4190U Remote Point Mod is a 2 zone expander which allows use the available expansion zones provided ADEMCO controls that support polling devices e g Vista 40 Vista 50P The 4190U consists of two protec loops known as the left primary and secondary loops The left loop can used for devices with or without supervision devices with EOLR super 10 millisecond devices the chart to the right for cutting the jumpers and choosing the correct when using the left loop right loop can be used for devices only no EOLR supervision millisecond response time jumpers do not affect the operation of right loop The zone number for the left is determined by the DIP switches the right loop is automatically one zone higher than the left The right loop be used alone tamper supervision response of the is determined by the zone response assigned to the left loop zone While system is armed tamper supervisory will report as alarms if the left loop is assigned a burglary response type will report as troubles if the left loop is assigned a non burglary response i e fire panic aux While the sys is disarmed tamper supervisory will report as troubles TABLE FOR DIPS WITH OFF OFF SWITCH POSITION ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON ON