Ademco - 5625 Installation Aid

GENERAL INwR TIOW No 5625 Installation System between selection with a 5600 Series Wireless optimum permitting the the system 5625A SA5625A Automatic Contact Operator No 5625 includes and a 5625 SA5625T 5625T to early production A 1OOK ohm resistor when b An adapter 5620 Receiver Controls Diagram 2 Diagram No 5605 Smoke use in connecting be used portable radio the 5625T Of OPERATIOR No 5625 is system be installed 5625T Field Strength Transmitter tone coded one receipt signal or audible an installer carried bursts No 5620 Receiver Control an acceptable caused Diagram 3 protective RF signal No 5631 or 5632 RF signal by the receiver heard radio bursts the system number of of made to bursts a protective FM radio RF signal strength coded RF signal best one which protective any one proposed tone bursts example tone bursts the one yielding between preferable 3 tone bursts receiver protective better another location be used since tones tones bursts an unreliable good or 4 tones no tones at all poor bursts be used use in screw terminals Nos 5603 5610 5611 and 5614 possess 5625A is produce periodic alternately and closes a circuit of protective connection of a closed protective an automatic 5625A acts device Operating Diagrams 1 and 3 battery GENERAL SPECIFICATIONS section 5625A battery connector of of 5625A supplied mating the No 5603 5610 5611 or 5614 as follows an appropriate with screw the described system switches been properly appropriate connected a No 5610 is used disconnect the wedge shaped marks on the side of magnet end of place position 5625A cable clips should be simultaneously as to polarity necessary 5625A after 5625A cable output which will OW position few seconds normal LED thereon and RF signal closing each opening and 5625A is small enough to be inserted cable radio as described belt while next section user user enough to permit or alterna bursts the FIEIJI STRECIGTH TRANSMITlER 5625T is designed Diagrams 2 and 3 system 5620 No 5631 or 5632 Receiver wireless a TEST mode 5625T neat mating connector No 5620 Receiver Control will system connect 5625A cable Early production of adapter make this Diagram 2 mounting clip with unit provided edge of the 5625T which permits No 5620 be temporarily connect 5625A RD 5603 or 5611 Transmitter RF signal described system mceivet previous on a portable vicinity 93 MHz radio 5625T until proximity RF signal used FM radio consistently are heard at FM radio burst of each 5625T need be done only be adjusted necessary 5625A which was connected all of conduct premises where described 4 FM radio be Installed section PATH TESTIffi MITES each protective be tested sultches been properly appropriate checked must yield tone consistently the 5603 5610 5611 or 5614 Door Window Transmitter the 5625A as described Transmitter No 5610 adjacent of across will preferred necessary to cause repeated position While magnet No 5610 wedge shaped alignment marks on its also be disconnected unit RF signals time any of Its unit bursts portable radio depressed any key and listen depressions FIRE FIRE POLICE POLICE etc required various hour al