Ademco - 5800SS1 Wireless Glassbreak Detector

10 01 Shock Sensor GUIDE INFORMATION When programming the shock sensor number 5800SS1 is a wireless shock sensor for use in systems that support 5800 devices Each transmitter has its own during which must be in the panel before the device can be used the system Refer to the control panel and Setup Guide for programming 5800SS1 is required for each pane of glass Do not use more than one sensor pane Plate Type of Glass Protection Wired Insulated It is not necessary to remove the case during installation THE 5800SS1 must enroll the 5800SS1 serial number in control panel during zone programming control panel Installation and Setup Before programming perform the cause the transmitter to transmit TO CONNECT tab see Figure 1 For transmissions lightly tap on base of with TO CONNECT BATTERY 1 the following Type 3 Supervised RF Number 1 When prompted for the serial number can transmit by lightly tapping on the of the sensor with a screwdriver or manually entering the serial and loop Determine mounting For best sensitivity the sensor be mounted one inch from the edge of the window frame see 2 AT WITH FT RADIUS 1 INCH FROM CORNER WINDOW FRAME 2 Before permanently conduct Go No Go tests see instructions to verify adequate mounting Always verify range by holding the sensor the approximate mounting location and at the base The panel in test If not find a more suitable location Clean the glass where the sensor will be with a mixture of water and alcohol Once the glass has dried remove the tape paper and firmly press the sensor the desired mounting location Verify operation by striking the furthest corner of the glass with the of a large screwdriver Always the alarm panel keypad to verify the zone has tripped Apply optional label to the glass surface opposite the tape side the 5800SS1 THE BATTERY Using a screwdriver carefully remove the cover Check the battery polarity orientation installing see Figure 3 the battery securely in the sensor the sensor cover back in place Coverage Laminate Wired Sealed Insulated and Tempered up to 6.35 mm and ft 3.048 m distance from mounting One sensor is required for each pane of glass H x 1.6 W x 0.8 D 40.64 mm x 40.64 x 20.32 mm 3V Panasonic CR2 Sanyo CR2 or DLCR2 Lithium Battery of fire explosion and burns Do not disassemble heat above 212 F 100 or incinerate Dispose of used batteries Keep away from children NOTICE ID CFS8DL5800SS1 device complies with Part 15 of the Rules Operation is subject to the two conditions This device may not cause harmful This device must accept any may operation 3 THE INSTALLER maintenance and inspection at least annually by the installer and frequent testing the user are vital to continuous satisfactory operation of any alarm system installer should assume the responsibility of developing and offering a regular program to the user as well as acquainting the user with the proper operation limitations of the alarm system and its component parts Recommendations must be for a specific program of frequent testing at least weekly to ensure the system operation at all times WARRANTY INFORMATION AND DETAILS REGARDING THE LIMITATIONS OF ENTIRE ALARM SYSTEM REFER TO THE INSTALLATION INSTRUCTIONS FOR RECEIVER CONTROL USED WITH THIS DEVICE Eileen Way Syosset NY 11791 2001 10 01