Ademco - 5878 User Manual

GUIDE 6 06 Rev A Wall Transmitter INFORMATION 5878 is a compact 6 button wall mounted transmitter that permits an alarm system home automation devices to be controlled The transmitter is typically used for system arming and panic and controlling relay operations associated with home devices Check with your installer for of the buttons on your unit THE BUTTONS activate a programmed function press and hold associated button s down The LED will flash to indicate the unit has transmitted in mode or red to indicate it has transmitted High Security mode order to minimize the possibility of transmissions the buttons on 5878 must be pressed and held for at 1 2 second to activate the 1 5878 Transmitter 1 Transmitter Functions this table with your installer BATTERY INDICATION a Button is pressed and a Low Battery exists a message is transmitted to the panel and LOW BAT will be displayed on keypad The LED will not during if the battery is low the Battery Slide out the battery tray located at the bottom Carefully remove the battery Press and hold any button for at least one the 5878 Insert a new battery in case back location as in Figure 2 Positive end must face Use Maxell CR2032 Duracell DL 20325 or CR2032 lithium battery only Slide the battery back into the 5878 Press any button and verify that the LED to the transmitter will SIDE FACE UP 2 Replacing the Battery STATEMENT sent by wireless transmitters may be blocked or reflected by metal objects before they reach the alarm receiver if the signal path has been recently checked during a weekly test blockage can occur if a metal object somehow the signal path button type transmitters that have visual and audible indications of status must be used to confirm that the action such as arming has occurred after pressing a function button on any of these transmitters Be sure to for appropriate audible and visual indications that such action has occurred Otherwise you could inadvertently yourself or your premises unprotected factors such as humidity high or low temperatures or constant activation of a programmed button may battery life in a given installation If the button unit is used infrequently activate it regularly once per week confirm operation A button type transmitter will report a low battery condition to the alarm control when a low status is detected WARRANTY INFORMATION AND FOR DETAILS REGARDING THE LIMITATIONS OF THE ENTIRE ALARM SYSTEM TO THE INSTALLATION INSTRUCTIONS FOR THE RECEIVER CONTROL WITH WHICH THIS DEVICE IS USED AND INDUSTRY CANADA STATEMENT DEVICE COMPLIES WITH PART 15 OF FCC RULES AND RSS210 OF INDUSTRY CANADA OPERATION IS SUBJECT THE FOLLOWING TWO CONDITIONS 1 THIS DEVICE MAY NOT CAUSE HARMFUL INTERFERENCE AND 2 THIS MUST ACCEPT ANY INTERFERENCE RECEIVED INCLUDING INTERFERENCE THAT MAY CAUSE UNDESIRED USER SHALL NOT MAKE ANY CHANGES OR MODIFICATIONS TO THE EQUIPMENT UNLESS AUTHORIZED BY THE AND SETUP GUIDE OR THE USER GUIDE Brookprinter Place Poway CA 92064 2006 Honeywell International Inc 6 06 Rev A