Ademco - 650MK Flush Mounting Kit Installation Instructions

1 HOLES 4 Cut opening in wail by making use of this Cut 4 1 Diameter holes and then top bottom and sides of round cornered Insert c o 650MK into opening with TOP as in diagram Insert 4 sprin clips provided into slots in 650MK us se either of the two slots at corner Secure spring clips with screws provided Insert into self threading holes and tighten part of each clip down against its spring thus holding the No 650MK securely place See Section Guide conductors detector and mount in No 650MK as follows Engage at lower edgeof No 650MK into bottom detector housing base and secure base to at upper edge of No 650MK Use the hex head screws provided with thedetector WALL PLATE provided with the detector is needed TX Nos 650,651 Series Motion Detectors DEPTH DEVICE MANUFACTURINO CO awya Q rn V rT c n Eileen Way Syoss New York 11791 9 91 Copyright 1991 PITTWAY CORPORATION