Ademco - 9719 End Of Line Resistor Module

No 9719 OF LINE MODULE BULLETIN A 9719 NOT DISCARD Operation 9719 module used convert normally and detectors a fully supervised output The module operates 16ma at 6VDC and 24ma at 12VDC A 3.3K ohm resistor required at the end of the A 25 change of state of the protective will cause normally 6 to 12VDC and only to establish de energize quiescent module packaged a fiber glass housing with sided self sticking The contacts mounting Removing a smooth of power causes rated a maximum Also tape cover will insure a fully relay contacts 125VDC 100 MA end of line resistor supplied with 6 inch inch can be soldered the circuit labeled wire appliance material with a minimum of taped or crimped 22 AWG The the last 9719 can be used with up to 56 glass break sensors N O and N C contacts within intermix 9715 and or 9716 lt end of line loop also A above depicts a typical N O and N C contacts with 9719 module Contacts 9719 9715 is a nonlatching seconds upon glass break break sensor which will change state of the 9719 for Reset Location 9716 is a latching of four seconds a normally open To reset the power to the 9179 or 9716 must be interrupted break sensor which will upon glass break change 9719 a PllTWAY CORPORATION