Ademco - Model AM, AML, AML-24, V-AML Troubleshooting Guide

TROUBLESHOOTING i L DRAIN OF PROTECTIVE CIRCUIT POWER SUPPLY OF PROTECTIVE CIRCUIT BATTERY OR REPEATED CAUSE and 4 of wires protective and Part Section Repair wires pinching sensitive and 6 Replace Part Section a RINGS BUT DOES NOT GIVE FULL SOUND also Part Section CAUSE bell power of a rechargeable sure I ly charged hours without charge I rechargeab operating bell e batteries charge of does not conform also Section bel wiring mounting caused bell binding Section bell avoid bell rcu i i s will with bell E necessary and 2 on coil ohms of Replace 50 ohms corroded contacts 2 of corroded spray 316 and 317 CIRCUIT DOES NOT LATCH ON ALARM WHEN THE CONDITION CAUSING ALARM CORRECTED THE BELL STOPS EVEN THOUGH THE KEYSWITCH REMAINS POSITION THE CAUSE and Clean and 317 circuit and 2 on coil ohms with ohm Replace ohm open circuit coil SYSTEM ARMED BELL DOES NOT OPERATE WHEN PROTECTIVE CIRCUIT also Part Section on CAUSE protective entry each contact necessary power discharged I ly charged sure Recharge hours without power of operating bell and not measure 6 volts bel bell and 2 on shorted C wiring needed Part protective and 6 on control and 317 corroded bell J circuit 2alay coil ohms of or adjust necessary clapper open coil ohmmeter SOUNDS WHENEVER KEYSWITCH TURNED TO ON POSITION CAUSE protective sensitive Check Part Section sensitive and 2 on and 6 Visually burnish Replace cure 316 and ALARMS OCCUR OUR TO SWINGERS HI PROTECTIVE CIRCUIT also CAUSE protective batteries during of 4 ma current volts ma Use No equivalent Part for Replace sure defective Recharge A Packs hours without corroded Replace READING ON CONTROL PANEL NORMAL READING WITH DRY CELLS USED WITH RECHARGE A PACK CIRCUIT TEST POSITION ZERO OR LESS THAN 3 AIL POSITIONS WHEN USING MODEL PROTECTIVE CIRCUIT 3 4 6 MA CAUSE protected entry open battery protective Check a I I w Fndows and doors protective opened windows Replace shorted battery ife sure CAUSE hours without break protect Be sure Recharge A Packs