Ademco - Vista 20P Installation Manual

File Preview
File Preview
Click below to download for free

File Data

Name ademco-vista-20p-installation-manual-9584702316.pdf
Type PDF
Size 1.85 MB
Downloads

Text Preview

cid 1 cid 2 cid 3 cid 4 cid 5 cid 6 cid 7 cid 8 cid 9 cid 10 cid 11 cid 10 cid 1 cid 2 cid 3 cid 4 cid 5 cid 6 cid 7 cid 8 cid 9 cid 12 cid 13 OFF MAX TEST STAY OFF MAX TEST STAY 7 01 FOR PROPER PROTECTION Following Recommendations for the Location of Fire and Burglary Detection Help Provide Proper Coverage for the Protected Premises For Smoke And Heat Detectors regard to the number and placement of smoke heat detectors we subscribe to the recommendations in the National Fire Protection Association NFPA Standard 72 noted below warning fire detection is best achieved by the installation of fire detection equipment in all rooms areas of the household as follows For minimum protection a smoke detector should be installed of each separate sleeping area and on each additional floor of a multi floor family living unit basements The installation of smoke detectors in kitchens attics finished or unfinished or in is not normally recommended additional protection the NFPA recommends that you install heat or smoke detectors in the living dining room bedroom s kitchen hallway s attic furnace room utility and storage rooms and attached garages addition we recommend the following Install a smoke detector inside every bedroom where a smoker sleeps Install a smoke detector inside every bedroom where someone sleeps with the door partly or closed Smoke could be blocked by the closed door Also an alarm in the hallway outside not wake up the sleeper if the door is closed ROOM ROOM ROOM Detectors for Minimum Protection Detectors for Additional Protection Detectors RM CLOSED Install a smoke detector inside bedrooms electrical appliances such as heaters air conditioners or are used Install a smoke detector at both ends of a if the hallway is more than 40 12 meters long Install smoke detectors in any room where alarm control is located or in any room alarm control connections to an AC or phone lines are made If are not so located a fire within room could prevent the control from a fire or an intrusion CONTROL COMPLIES WITH NFPA FOR TEMPORAL PULSE OF FIRE NOTIFICATION For Proper Intrusion Protection proper intrusion coverage sensors should be located at every possible point of entry to a home or premises This would include any skylights that may be present and the upper windows in multi level building addition we recommend that radio backup be used in a security system so that alarm signals can be sent to the alarm monitoring station in the event that the telephone lines are out of order alarm are normally sent over the phone lines if connected to an alarm monitoring station Of Contents 1 Features and Installation Highlights 1 1 1 1 1 1 Devices 1 2 Installation Highlights Installer Please Read 1 2 2 Mounting and Wiring the Control 2 1 and Lock 2 1 the PC Board Alone 2 1 Board with RF Receiver 2 2 to Keypads 2 3 Bell Connections 2 4 the AC Transformer 2 4 Battery 2 5 Ground 2 5 Zones 2 6 Balanced Zones 2 6 Doubling 2 6 Detectors 2 6 Expansion Zones 2 7 the RF Receiver 2 8 a 5800TM Module 2 8 the Transmitters 2 8 a Keyswitch 2 9 Relay Modules 2 10 Carrier Devices 2 11 Triggers 2 11 Line Phone Module Connections 2 12 Range Radio Connections 2 13 Connections 2 13

Related Files