Ademco - Vista 40 Installation Manual

2 Partitioned Security System Control Supports the Ademco Voice Interface Module VIM Audio Alarm Verification AAV Instructions Installation Instructions Installation Instructions 6 97 of N7001V2 FOR PROPER PROTECTION Following Recommendations For The Location Of Fire And Burglary Detection Devices Help Proper Coverage For The Protected Premises For Smoke And Heat Detectors regard to the number and placement of smoke heat detectors we subscribe to the contained in the National Fire Protection Association NFPA Standard 72 noted warning fire detection is best achieved by the installation of fire detection equipment in all rooms and of the household as follows For minimum protection a smoke detector should be installed outside each separate sleeping area and on each additional floor of a multi floor family living unit including The installation of smoke detectors in kitchens attics finished or unfinished or in garages is normally recommended additional protection the NFPA recommends that you install heat or smoke detectors in the living dining room bedroom s kitchen hallway s attic furnace room utility and storage rooms and attached garages addition we recommend the following a smoke detector inside every bedroom where a smoker sleeps a smoke detector inside every bedroom where someone sleeps with the door partly or closed Smoke could be blocked by the closed door Also an alarm in the hallway may not wake up the sleeper if the door is closed a smoke detector inside bedrooms where electrical appliances such as portable heaters air or humidifiers are used a smoke detector at both ends of a hallway if the hallway is more than 40 feet 12 meters smoke detectors in any room where an alarm control is located or in any room where alarm connections to an AC source or phone lines are made If detectors are not so located a fire the room could prevent the control from reporting a fire or an intrusion ROOM ROOM ROOM Detectors for Minimum Protection Detectors for Additional Protection Detectors RM CLOSED This control complies with Fire Protection Association requirements for temporal pulse of fire notification appliances For Proper Intrusion Protection proper intrusion coverage sensors should be located at every possible point of entry to a home or premises This would include any skylights that may be present and the upper windows in a building addition we recommend that radio backup be used in a security system so that alarm signals can still be to the alarm monitoring station in the event that the telephone lines are out of order alarm signals are sent over the phone lines if connected to an alarm monitoring station 2 OF CONTENTS 1 INSTALLATION INSTRUCTIONS Part 1 when installing the hardware components of the installation 2 4 1 GENERAL OF SYSTEM FEATURES TO THE PARTITIONED SYSTEM THE CONTROL THE CABINET LINE CONNECTIONS INTERFACE MODULE VIM 3 POWERING THE SYSTEM Power Power Ground Connections Procedure Loop Current Draw Worksheet Device Current Draw Worksheet REMOTE KEYPADS The Keypads The Keypads Keypads the Keypad Address Additional Keypads 2 Way Voice Keypads Interface Module VIM Connection 5 ZONE CONFIGURATIONS 9 HARD WIRED ZONES Information 1 Smoke Detectors 2 Glass Break Detectors 9 POLLING LOOP EXPANSION Zones 10 through 64 Information Interference Polling Loop Devices EXPANSION Zones 1 Information Series Receiver Series Receiver with RF Keys 5801 etc Using 5827BD 5800TM Wireless Keypad Transmitter Module Zone Types Annunciation Battery Notice 5700 Series Wireless Devices 5800 Series Wireless Devices TRIGGERS Connector J7 Information Start Module Keyswitch