Andover Controls InfiLink 200 Installation Guide

Controlling Tomorrow World 200 Guide Version Controls Corporation Manuals Online! – C or distribution forbidden. (cid:211) 1992 by Andover Controls. to change without notice. No. 30-3001-178 1992 (cid:211) Controls Corporation Brickstone Square Massachusetts 01810 Rights Reserved. NOTICE by the Engineering Department at Andover Controls Corporation. product is subject to change without notice. This document does not con- any warranty, express or implied. Andover Controls Corporation re- the right to alter capabilities, performance, and presentation of this at any time. 200 Installation Guide Manuals Online! – InfiLink 200 Installation Guide presents instructions for installing InfiLink 200 on the Infinet, a network of local controllers. It first how to prepare the site, including facts about proper ground- then how to install the InfiLink 200. basic information on local area networks (LANs), refer to the Network Configuration Guide or ICS Network Configuration Controls Corporation Manuals Online! – 200 Installation Guide Manuals Online! – the InfiLink 200 Infinet manual covers installing the InfiLink 200 on Infinet. For on how to plan and set up your network, refer to the and Infinet Configuration Guide. Registration warranty is effective for 18 months starting on the date the system shipped. wiring must comply with all local, state, and national electrical 200 Installation Guide Manuals Online! – the InfiLink 200 the InfiLink 200, the maximum cable length for all arms on is 4,000 ft. at 19,200 baud (up to 32 local controllers). The In- 200 amplification module lets you extend Infinet beyond 4,000 or have more than 32 local controllers. is also an active hub that can connect up to 127 local controllers to the in a star configuration. you can install the InfiLink 200, you need to know some basic about it: its dimensions and enclosure, power requirements, requirements, and environmental requirements. equipment generates, uses, and can radiate radio frequency energy if not installed and used in accordance with the instruction manual cause interference to radio communications. It has been tested and to comply with the limits for a Class A computing device to Subpart J of Part 15 of the FCC Rules, which are designed provide reasonable protection against such interference when in a commercial environment. Operation of this equipment in residential area is likely to cause interference in which case the user his own expense will be required to take whatever measures may be to correct the interference. 200 Dimensions 7.5 Each InfiLink 200 is 8.5 enclosure that meets UL standards. 2.75 in. The unit is inside a hinged 200 Installation Guide Manuals Online! – Requirements sure your installation complies with local, state, and national codes. InfiLink 200 should receive power from its own independent, circuit. 200 requires 120 V +10/ 60 Hz. You can select 230 50 Hz for European sites by setting two jumpers, but for smoke applications, you must use 120 VAC +10/ 60 Hz. select the input voltage. When you receive it, it is set to 120 V. for altering the input voltage are included later in this Ground Requirements sure that all hardware from Andover Controls Corporation is to true earth ground. This kind of ground protects the from lightning strikes and other power surges in the area. 200 Installation Guide Manuals Online! – cannot guarantee that the control system will operate as unless you properly ground all controllers. 200 Installation Guide Manuals Online! – sure to have your grounds inspected before you begin the process to be sure