Autocall A4606-9101 LCD Annunciator for 4006 Fire Alarm Control Panels

Datasheet Accessories, LCD Annunciators LCD Annunciator for 4006 Fire Alarm Control Panels 1: LCD Annunciator Scrolling. operation of the appropriate acknowledge switch will scroll LCD display showing activity in the sequence of occurrence. The tone-alert also sounds to indicate the operation of any of the switches. Access. All switches on the annunciator are controlled by “ENABLE” keyswitch with a key that is removable only in the disabled Operations. When enabled, notification appliances can be by pressing the “ALARM SILENCE” switch. Pressing the RESET” switch restores the system to normal operation. When activity is normal, the LCD displays the time, date, and “SYSTEM NORMAL.” ULC, CSFM Listed, FM LCD annunciator for use with Autocall model 4006 fire control panels readout provides: Two lines of 40 characters each Wide viewing angle, super-twist design LED backlighting switches and status LEDs for: Alarm, supervisory, or trouble acknowledge (keyswitch access Alarm silence System reset programmable LED indicators: Two LEDs are selectable as red or yellow One LED is selectable as green or yellow With provisions for custom labeling features: Information is transmitted over a single twisted, shielded pair; separate is required for 24 VDC control panel power Tone-alert sounder provides local audible indication Lamp and LCD are functionally tested each time the keyswitch is on Mounts flush on standard 6-gang electrical box and trim options: Surface mount box model 2975-9206 (ordered separately, see LCD Annunciator Specifications) Brushed stainless steel trim model A4603-9111 (ordered separately) Annunciation. LCD Annunciators allow compatible fire alarm control to provide information and control switches at convenient away from the control panel. The LCD is an 80 character, alphanumeric display with information presented in clear and English. Typical content includes: point status (alarm, trouble, alarm type (smoke detector, manual station, etc.), number of alarms, supervisory conditions, troubles, and custom location up to 40 characters long. (Some 4006 messages are limited to characters, refer to the control panel documentation for additional communications require a single twisted, shielded pair that other annunciators on the same communications channel. 4006 Series panels control up to four annunciators. Supervisory, and Trouble conditions are also indicated by LEDs and a tone-alert audible indication. Each condition has a acknowledge push-button switch that silences the tone-alert leaves the LED on until all conditions in that category are restored to This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 7300-2269:0569, 7300-2269:0567 and 7300-0026:0381 for allowable values and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local supplier for the latest status. Rev. 10 03/2021 LCD Annunciator for 4006 Fire Alarm Control Panels Selection 1: Product Selection LCD Annunciator with beige trim stainless steel trim option surface mount box; ivory finish matching resistor harness; 100 1/2 W; (reference no. 733-974) protector; required where annunciator communications and power wiring exits and enters a building; refer to data AC2081-0016 for details to A4606-9101 LCD Annunciator for additional details LCD Annunciator Specifications 2: General Operating Specifications (refer to Installation Instructions 579-978AC for additional information) Operating Current Standby Current Current Temperature Range Humidity Range to 32 VDC, system supplied mA (with LED backlighting on) mA (during battery backup, LED backlighting is turned off after 30 seconds without switch activity) mA maximum (LED backlighting is