Autocall Auto-Aligning Reflective Beam Smoke Detectors with IDNet Communications

Datasheet Detection Products Reflective Beam Smoke Detectors with IDNet Communications 1: Addressable beam detector head ULC, CSFM Listed* reflective beam smoke detector system with IDNet addressable communications: Compatible with Autocall 4007ES, 4010ES, and 4100ES fire alarm units (FACUs) Autocall addressable beam smoke detectors add IDNet to the proven FireRay 5000 Series beam smoke system Communicates status information, and receives commands and threshold selection from the host FACU transmitter and receiver are combined in a single, housing: Connect up to two remote detector heads to one ground level An on-board microprocessor analyzes light reflected from an infrared reflecting from a matching prism Operating range covers 26 ft, 3 in. to 330 ft (8 m to 100 m) Modular design with easyfit mounting system and LASER assisted mounting provides convenient mounting and adjustment Auto-Align beam alignment operation conveniently rotates beam to to the prism center during installation AutoOptimise operation automatically maintains alignment for reliable UL 268 and ULC-S529 listed microprocessor controlled operation includes the Ground level system controller with LCD Operating voltage range 14 VDC to 36 VDC Easy setup and alignment with built-in electronic UL/ULC obscuration test selectable from host FACU Automatic gain control, contamination compensation, building shift with control and monitoring of alignment motors, and to change Delay to Fire and Delay to Fault timings FACU operations include the following: Sensitivity selection from 10% to 60% (35% default) Point type selection (Fire, Latched, Supervisory, or Utility) and set FACU information received includes the following: Smoke status, Controller-to-Detector Communications status, Rapid status (beam blocked), Self-alignment status, Almost status, Excessively Dirty status, and general summary Trouble Analog values for signal strength and compensation level, see for more information Dirty threshold beam head LED Initiate obscuration test, reset latched conditions, Enable/Disable, and accessories: 2: Addressable beam control station Large open areas such as warehouses, hotel atriums, industrial plants, school gymnasiums Public areas where cosmetics are of prime importance and detector need to be small and unobtrusive, such as shopping malls, theaters, and churches Detector: adjustment bracket, back box, and cover plate Controller back box Extended prism mounting options This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listing 7260-2269:0572 for allowable and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local Autocall product supplier for the latest status. AC4098-0049 Rev. 6 11/2021 Reflective Beam Smoke Detectors with IDNet Communications installation and alignment addressable beam smoke detection provides the proven FireRay 5000 system features of auto-aligning infrared beam smoke detection with IDNet addressable communications. When the detector head is installed using the easyfit mounting system, an integral laser can activated that alignes along the optical path of the infrared beam. Locating the reflective prism is quick and accurate using the Auto-Align beam feature. Beam Alignment AutoOptimise beam alignment system automatically steers and maintains the beam in the optimum position for reliable performance. The element generates the signal, the prism reflects it back to the receiver element, and then it is analyzed for the presence of smoke. The control station determines an alarm condition when it reaches the predetermined level. Alarm threshold levels are set using the host FACU. to Fire and Time to Fault are set using the