Autocall IDNet Isolator2 Compatibility Chart

IDNet Isolator2 Compatibility Chart this document to clarifiy which products you can use in conjunction with the IDNet Isolator2 and IDNet Isolator2 Bases. Refer to 579-1313AC Isolator2 Usage Guidelines for more information about Isolator2 usage. Some PIDs in the IDNet Isolator2 Compatibility Chart are also available with a BA suffix. In relation to the IDNet Isolator2 compatibility these PIDs are equivalent to the default PIDs. modules incompatibility following table details IDNet modules that are not compatible with the Isolator2. 1: IDNet modules that are not compatible with Isolator2 Isolator note or Part Number Board Assembly: Board Assembly: The modules listed in Table 1 do not recognize the Isolator2 devices. If Isolator2 devices connect to equipment identified in Table 1, the Isolator2 will report a answer trouble on the control unit. However,other devices downstream will continue to communicate with the control unit. devices incompatibility can not connect the devices listed below to the IDNet2 channel alongside the IDNet Isolator2 where ULC S524 7th edition isolator requirements be met (even when all other software and hardware assembly revisions on the IDNet2 channel meet the Isolator2 compatibility requirements). If you use equipment listed in Table 2 on the IDNet2 channel alongside the IDNet Isolator2, all operation except compliance with ULC S524 7th isolator requirements will function properly. A4090-9107 A009-9811 A4098-9793 2: IDNet2 channel equipment Fiber Transmitter Fiber Receiver Repeater Isolator Isolator Base modules revision compatibility the following section to identify the specific module revision for Isolator2 compatibility. For ULC S524 7th edition compatibility, make sure the and PC Board assemblies meet the minimum revisions below. 3: ULC revision compatibility IDNet2, IDNet2 Loop Card, 4007ES NAC PSU and IDNAC PSU or Part Number / IDNet2+2 Board Assembly Revision Revision D or later Revision Requirements 3.01 or higher 6.01 or higher Loop Card Revision C or later Revision C or later Rev A Isolator2 Compatibility Chart or Part Number Revision Requirements 3: ULC revision compatibility IDNet2, IDNet2 Loop Card, 4007ES NAC PSU and IDNAC PSU NAC PSU Board Assembly Revision Revision F or later IDNAC PSU Revision D or later 3.01 or higher 6.01 or higher 3.01 or higher 6.01 or higher or Part Number MSS2 Board Assembly Revision Revision A or later Revision Requirements 3.01 or higher 6.01 or higher 4: ULC revision compatibility for 4010ES MSS2 or Part Number ESS Board Assembly Revision Revision C or later Revision Requirements 3.01 or higher 6.01 or higher 5: ULC revision compatibility for 4010ES ESS modules listed above recognize the Isolator2 devices and can communicate with them only if the software revision requirements are the assembly (566-XXX) revision requirement is not met but the software is, then the following applies: Class A / DCLA or Class X / DCLC operation can not be guaranteed to work to ULC S524 7th edition. Class B / DCLB operation meets ULC S524 7th edition. All products sold after the release of the Isolator2 meet the minimum requirements. 2 Rev A devices PC Board assembly compatibility ULC S524 7th edition compatibility, make sure the PC Board assemblies of the active field devices meet the following minimum revisions. Isolator2 Compatibility Chart 6: PC board assembly revision requirements