Autocall LED_Switch Annunciator Model A4610-9111 and Accessories

Datasheet Accessories, LED Annunciators Annunciator Model A4610-9111 and Accessories System Annunciators. communications for these panels can include up to devices, including the LED/Switch Annunciator; an LCD Remote and the optional host panel door-mounted LED Information. to LED/Switch Annunciator Installation Instructions 579-710AC and the host panel instructions. 1: General Specifications Current Current Temperature Humidity to 33 VDC, system supplied mA mA maximum (all LEDs and tone-alert on) to 120 F (0 to 49 C) to 93% RH, non-condensing at 100 F (38 2: Annunciator Communications Supported Type for wiring to building Wiring Connections to four annunciator modules per panel pair, or twisted, shielded pair; 18 AWG mm2) to 4000 ft (1219 m); 0.58 (580 nF) capacitance; 35 maximum to 10,000 ft (3048 m) total wiring; up to ft (762 m) to farthest device one at panel and at end of line one at panel and at farthest device A2081-9044 Overvoltage Protectors where leaves and enters a building (refer to sheet AC2081-0016 ) VDC system power and Earth ground for box (ground per local code) for in/out wiring; 18 to 12 AWG (0.82 to 3.31 mm2) 1/2 W; PID (part 733-974) 3: Mounting Information Dimensions Material for Flush (supplied by W x 4-1/2″ H (254 mm x 114 mm) steel, red 5-gang boxes with conduit entrance refer to installation information in Information. ULC, CSFM Listed, FM LED/Switch annunciator for the Autocall 4006 fire alarm panel with: 16 LEDs with functions programmable at the host panel to indicate system conditions and locations (Alarm, Supervisory, Trouble, Dedicated LEDs that indicate Alarm Silence, Trouble, Communication and Power-on Local tone-alert audible indicator access control switches provide: Event Acknowledge, Alarm Silence, System Reset, and local Lamp Test LED options: 10 Red LEDs to indicate Alarm conditions by programmable area 6 Yellow LEDs to indicate Trouble conditions Custom label inserts describe LED functions requirements: Twisted pair for communications 24 VDC system power via separate wiring options: Flush mount uses standard 5-gang electrical boxes Listed to Standard 864, 9th Edition 1: LED/Switch Annunciator LED Annunciation. A4610-9111 LED/Switch Annunciators provide remote fire system status and control with 16 programmable LEDs to provide specific information. Keyswitch controlled access allows switches to activate Acknowledge, Alarm Silence, system or local Lamp (LED) Test. Label inserts allow custom LED specifics be identified. LEDs and Remote Switch Control. indicate Alarm Silenced, Communications Loss with panel, Trouble, local Power-on, along with a local tone-alert audible indication. the Acknowledge push-button switch silences the system but leaves the LEDs on until all conditions in that category restored to normal. LED operation (continuous or pulsing) is at the control panel. This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 7300-2269:0569, 7300-2269:0567 7300-0026:0381 for allowable values and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local product supplier for the latest Rev. 4 03/2021 Annunciator Model A4610-9111 and Accessories Selection Detail View 4: Product Selection Annunciator, red trim matching resistor; 100 1/2 W; (part number 733-974); see specifications on page 3 for location and quantity protector; required where annunciator