Home » Autocall Remote Emergency Telephone Equipment A2084 Series Firefighter Telephones Datasheet
File preview
Click the button below to download immediately for free
Show text preview
Datasheet Alarm Fire Alarm Systems Emergency Telephone Equipment A2084 Series Firefighter Telephones 4: Door and Trim, Surface Mount 5: Door and Trim, Flush Mount Pull Handle and Break-Rod ULC, CSFM Listed* telephones provide direct communications with the Telephone Control master phone: When remote phones call the master, a call tone is provided to verify the request is in process (exact performance may vary depending master phone equipment) Two-wire telephone circuits are supervised and power-limited Compatible with 4100ES Series Autocall Firefighter Telephone Controls assemblies are available for the following: Surface or flush mounting Backbox is ordered separately Or as separate phone sets for plugging into dedicated remote phone stations options: Break-rod door latch allows access during emergencies Armored cable models to minimize vandalism (voice and ear caps are with adhesive) Push-to-talk (PTT) phones provide input control at the remote phone Magnetic latch models with “Fire Warden Station” marking and LED call Additional options are listed in Table 2 and Table 3. Accessories: Replacement break-rod Listed to Standard 864 telephone systems provide two-way communications facilities where radio communications may not be available or are They are typically used during active firefighting conditions, a fire alarm investigation, or during fire alarm system inspection test. requires a dedicated two-wire circuit, typically using twisted, pair wiring (TSP) to minimize electrical noise pickup from wiring. Depending on the master control, up to 6 remote and the master can be in simultaneous use. For additional refer to installation instructions 579-226AC, and datasheet which describes 4100ES Master phone control operation. 1: Phone Station 2: Phone Station 3: Jack 976200 This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 6912-2269:0545 for allowable and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local product supplier for the latest status. Rev. 12 4/2021 Emergency Telephone Equipment A2084 Series Firefighter Telephones phones are typically stored in a cabinet at the central control area where they would be conveniently located for fire fighters other authorized personnel. They are compatible with commercially storage cabinets. Red Pluggable Phone, Push-to-Talk. This phone is the as the A2084-9014, except it is equipped with a large and easily push-to-talk switch located on the inside handle between the and transmitter. 7: A2084-9014 Pluggable Phone phone jacks and Mounting. Phone jacks are mounted on a stainless steel plate for use with pluggable phones. The front is marked red “FIRE EMERGENCY PHONE” lettering. Mounting requires a electrical box, 2 in. (51 mm) minimum depth. In/out wiring is color-coded 18 AWG (0.82 mm2) wire leads. A2084-9001 is standard. Model A2084-9023 is similar to but also provides an LED indicator powered from the phone wiring. The LED is activated when “Call-Out” is selected the Master phone, a request for the responding personnel to plug in phones and communicate with the master. phones, cabinet mounted Information. Doors and trim are painted red and available surface or flush mounting. The doors are silk-screened in white with FIRE EMERGENCY PHONE” or other options, see Table 2. Door Option. This mounting type provides a glass break- similar to those used in manual fire alarm stations. The break-rod positioned inside the door such that pulling the door handle breaks rod and allows the door to open. A standard lock is also provided to authorized entry without breaking the rod. Options. Armored cable phones include voice and ear caps with adhesive to minimize vandalism. They are also available with switches that allow the user to mute the transmitter until is required. Phone handsets are constructed of Cycolac type T, a ABS material. Fire Warden Station. This moun
Datasheet Alarm Fire Alarm Systems Emergency Telephone Equipment A2084 Series Firefighter Telephones 4: Door and Trim, Surface Mount 5: Door and Trim, Flush Mount Pull Handle and Break-Rod ULC, CSFM Listed* telephones provide direct communications with the Telephone Control master phone: When remote phones call the master, a call tone is provided to verify the request is in process (exact performance may vary depending master phone equipment) Two-wire telephone circuits are supervised and power-limited Compatible with 4100ES Series Autocall Firefighter Telephone Controls assemblies are available for the following: Surface or flush mounting Backbox is ordered separately Or as separate phone sets for plugging into dedicated remote phone stations options: Break-rod door latch allows access during emergencies Armored cable models to minimize vandalism (voice and ear caps are with adhesive) Push-to-talk (PTT) phones provide input control at the remote phone Magnetic latch models with “Fire Warden Station” marking and LED call Additional options are listed in Table 2 and Table 3. Accessories: Replacement break-rod Listed to Standard 864 telephone systems provide two-way communications facilities where radio communications may not be available or are They are typically used during active firefighting conditions, a fire alarm investigation, or during fire alarm system inspection test. requires a dedicated two-wire circuit, typically using twisted, pair wiring (TSP) to minimize electrical noise pickup from wiring. Depending on the master control, up to 6 remote and the master can be in simultaneous use. For additional refer to installation instructions 579-226AC, and datasheet which describes 4100ES Master phone control operation. 1: Phone Station 2: Phone Station 3: Jack 976200 This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 6912-2269:0545 for allowable and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local product supplier for the latest status. Rev. 12 4/2021 Emergency Telephone Equipment A2084 Series Firefighter Telephones phones are typically stored in a cabinet at the central control area where they would be conveniently located for fire fighters other authorized personnel. They are compatible with commercially storage cabinets. Red Pluggable Phone, Push-to-Talk. This phone is the as the A2084-9014, except it is equipped with a large and easily push-to-talk switch located on the inside handle between the and transmitter. 7: A2084-9014 Pluggable Phone phone jacks and Mounting. Phone jacks are mounted on a stainless steel plate for use with pluggable phones. The front is marked red “FIRE EMERGENCY PHONE” lettering. Mounting requires a electrical box, 2 in. (51 mm) minimum depth. In/out wiring is color-coded 18 AWG (0.82 mm2) wire leads. A2084-9001 is standard. Model A2084-9023 is similar to but also provides an LED indicator powered from the phone wiring. The LED is activated when “Call-Out” is selected the Master phone, a request for the responding personnel to plug in phones and communicate with the master. phones, cabinet mounted Information. Doors and trim are painted red and available surface or flush mounting. The doors are silk-screened in white with FIRE EMERGENCY PHONE” or other options, see Table 2. Door Option. This mounting type provides a glass break- similar to those used in manual fire alarm stations. The break-rod positioned inside the door such that pulling the door handle breaks rod and allows the door to open. A standard lock is also provided to authorized entry without breaking the rod. Options. Armored cable phones include voice and ear caps with adhesive to minimize vandalism. They are also available with switches that allow the user to mute the transmitter until is required. Phone handsets are constructed of Cycolac type T, a ABS material. Fire Warden Station. This moun