Autocall SmartSync 2-Wire Operation, Non-Addressable Multi-Tone Horns

UL, ULC, CSFM Listed, FM* Notification Appliances 2-Wire Operation, Non-Addressable Multi-Tone Horns current, 24 VDC Autocall SmartSync operation electronic horns provide: Per appliance tone selection of: Horn, Bell, 500 Hz Horn, Canadian Slow Whoop, Siren, or Hi/Lo; selected using an on-board DIP (Note: 500Hz horn tone is not compliant with NFPA 72 Low Frequency Requirements for Sleeping Areas) Output level selectable as standard or high Rugged, high impact, flame retardant thermoplastic housings, available red with white lettering or white with red lettering Diode polarized input for connection to reverse polarity, supervised control Notification Appliance Circuits (NACs) two-wire control of audible and visible notification provides: Control of horn and bell tones as Temporal Pattern, March Time or on continuously; controlled separately from visible on the same circuit Slow Whoop, Siren, and Hi/Lo tone selections sound their tones synchronized to each other, when receiving SmartSync commands SmartSync March Time pattern produces a 60 BPM output for the 500 Hz Horn, and the Bell tone Visible appliances on the same circuit operate at a synchronized 1 Hz Refer to page 2 for SmartSync control list and additional operation notification appliance design provides flexible, easy, convenient semi-flush or surface wall mounting: Easily mounts to single gang, double gang, or 4-inch square electrical In/out wiring terminals, 18 AWG to 12 AWG Rear of housing does not extend into box accessories Mounting adapters to cover surface mounted electrical boxes and to to Autocall 2975-9145 boxes UL listed wire guard UL/ULC listed sound damper for locations requiring attenuation of 5 to dBA (stairwells, small rooms, highly reverberant areas, etc.) Covers are available separately to change color or for replacement reference UL listed to Standard 464 ULC listed to Standard S525 rate 1: Multi-Tone Horns are Available as with Red Lettering or Red with White Lettering non-addressable multi-tone horns provide a flexible of output tones for fire alarm audible notification. Tone and output level is set per appliance, allowing notification to be tailored to specific area requirements. (See Table 5.) Tone Selection. DIP Switch selection determines the local tone A separate DIP Switch position allows selection of a standard or high output sound level, selectable appropriate to the location. (See 5.) mounting. Multi-tone horns can be semi-flush or surface on a standard single gang, double gang, or 4 square (102 mm) box. Optional accessories are available to increase mounting application flexibility. two-wire control operation mode allows a two-wire circuit to provide the ability activate both the horn and strobe on the same NAC and then allow horn to be silenced while the strobe remains flashing. The horn as while the strobe operation is control sources two-wire control is available from: 4006, 4007ES Hybrid, 4010ES, 4100ES, and 4100U Fire Alarm Control (refer to individual product data sheets for more information) 4009 IDNet NAC Extenders SmartSync Control Module (SCM) Model A4905-9938 This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 7125-2269:0524, 7125-2269:0525 and 7135-0026:0334 for allowable values and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local supplier for the latest status. Rev. 5 2/2020 2-Wire Operation, Non-Addressable Multi-Tone Horns selection 1: Sound damper and adapters Sound Damper; package of 20; field installed adhesive backed output attenuator; reduces output 5 to 6 dBA After Sound Damper installation, measure sound level to ensure with applica