Autocall SmartSync Adapter Module for Non-Addressable Notification Circuits (NACs) Model A4905 9815

Datasheet Notification Appliances Adapter Module for Non-Addressable Notification Appliance Circuits (NACs) A4905-9815 CSFM Listed, FM Approved* the Autocall SmartSync NAC (notification appliance into separate 24 VDC audible and visible appliance Power and communications are supplied by the SmartSync operation You can connect up to two SmartSync Adapter Modules to a SmartSync Operation is compatible with SmartSync control from Autocall fire control panels and from 4009 IDNet NAC Extenders Operation modes are: visible and audible appliances both on; or visible only with activation determined by the connected control On-board circuit limits appliance inrush current and provides self- overcurrent protection Wiring to audible and visible appliances is supervised with conventional polarity operation; opens or shorts are reported to the control diagnostics: A visible status LED lights if a wiring fault is detected by either of the output notification appliance supervision circuits output ratings: Regulated 24 DC appliance power; audible output is rated for up to 30 visible output is rated for up to 180 mA Special Applications appliance ratings; audible output is rated for up to mA, visible output is rated for up to 250 mA mechanical features: Mounts in standard 4 11/16 in. (119 mm) square electrical box Cover plates, required, are available for surface or flush mount, separately Covers provide status LED viewing Screw terminals for wiring connections listed to Standard 864 Notification Requirements. Standard SmartSync operation appliances activate horns or strobes in response to received from the SmartSync operation control source using two-wire connection. For applications where appliances other than the SmartSync appliances are required, the SmartSync Adapter provides a separate audible and visible output controlled by the operation control source. applications are for connection to special weather-proof appliances with particular sound output characteristics, bells or chimes, or for connection to appliances that are required satisfy specific aesthetic requirements. SmartSync operation System Advantages. With the Adapter Module, you can control non-SmartSync appliances still benefiting from the SmartSync operation ability to provide audible and visible control using a two-wire connection. additional information refer to 4905-9815 SmartSync Adapter Instructions 579-391AC. 1: SmartSync Adapter Module, One-Line Wiring Reference Wiring Details with circuit protectors. When connected to remote up to 200 ft from the adapter, that exit the building and may exposed to harsh electrical environments, the notification appliance is compatible with Autocall circuit protectors. Compatible are listed in Specifications . Connect both where the wiring the building and where it connects to the appliances. for shielded wire. For applications where notification wiring may be exposed to electrical noise, twisted, shielded is recommended. The adapter wiring terminal block has for connecting the shields. This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 7300-2269:0535 and for allowable values and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local product supplier for the latest status. AC4905-0005 Rev. 7 08/2021 Adapter Module for Non-Addressable Notification Appliance Circuits (NACs) Model A4905-9815 Adapter Product Selection 1: TrueAlert Adapter Product Selection Adapter Module; requires surface or flush mount cover plate Resistor Harness (ref. 733-894AC); 10 k 1/2 W; two required, one each for audible and visible output Mount Cover Plate Mount Cover Plate one for each A4905-9815; painted beige