Autocall TrueAlert Addressable Adapter Module Model A4905-9816

Datasheet Addressable Notification Appliances Addressable Adapter Module Model A4905-9816 additional information refer to 4905-9816 4906 TrueAlert Adapter Instructions 579-390AC. 1: TrueAlert Addressable Adapter Typical One-Line Wiring Reference Wiring Details with circuit protectors. When connected to remote up to 200 ft from the adapter, that exit the building and may exposed to harsh electrical environments, the notification appliance is compatible with Autocall circuit protectors. Compatible are listed in Specifications . Connect both where the wiring the building and where it connects to the appliances. for shielded wire. For applications where notification wiring may be exposed to electrical noise, twisted, shielded is recommended. The adapter wiring terminal block has for connecting the shields. CSFM Listed, FM Approved* a single TrueAlert addressable notification address into 24 VDC audible and visible notification outputs: Power and communications are supplied by Autocall 4100ES, 4010ES, 4007ES fire alarm control panels equipped with power supplies provide advanced addressable notification from IDNAC Signaling Circuits (SLCs), and from 4009 IDNAC Repeaters** Operation is also compatible with TrueAlert SLCs from TrueAlert Power (TPS) or TrueAlert Addressable Controllers (4009T) You can connect up to two TrueAlert Addressable Adapter Modules to IDNAC SLC control output features: Operation modes are: visible and audible appliances both on; or visible only with activation determined by the control panel IDNAC On-board circuit limits appliance inrush current and provides self- overcurrent protection Wiring to audible and visible appliances is supervised with conventional polarity operation; opens or shorts are reported to the control output ratings: Regulated 24 DC appliance power; audible output is rated for up to 30 visible output is rated for up to 180 mA Special Applications appliance ratings; audible output is rated for up to mA, visible output is rated for up to 250 mA diagnostics: You can program a visible status LED at the connected control panel indicate polling status and can be activated for each address for testing mechanical features: Mounts in standard 4 11/16 in. (119 mm) square electrical box Cover plates (required) are available for surface or flush mount, separately Cover plates provide status LED viewing Screw terminals for wiring connections listed to Standard 864 Notification Requirements. IDNAC SLCs activate addressable horns or strobes in response to commands received from IDNAC SLC. For applications where appliances other than the TrueAlert addressable appliances are required, the TrueAlert Adapter Module provides a separate audible and visible individually activated by the IDNAC SLC. applications are for connection to special weather-proof appliances with particular sound output characteristics, bells or chimes, or for connection to appliances that are required satisfy specific aesthetic requirements. TrueAlert Addressable System Advantages. With the Addressable Adapter Module, you can control non-TrueAlert while still benefiting from the TrueAlert addressable system supervision to the Adapter Module, multiple diagnostic modes, supporting of T-tapped Class B wiring of the IDNAC SLC connections. This product has been approved by the California State Fire Marshal (CSFM) pursuant to Section 13144.1 of the California Health and Safety Code. See CSFM Listings 7300-2269:0535 and for allowable values and/or conditions concerning material presented in this document. Additional listings may be applicable; contact your local product supplier for the latest status. Use of “TrueAlert” in this document refers to both TrueAlert and TrueAlert ES notification appliances. Use of IDNAC SLCs also refers to operation of TrueAlert SLCs. AC4905-0004 Rev. 9 08/2021 Addressable Adapter Module Model A4905-9816 Addressable Adapter Product Selection 1: Product