Autocall 4100ES 4010ES Compatible External Battery Cabinet with Charger, A4081 Series

Datasheet Accessories Compatible External Battery Cabinet with Charger 4100 Series ULC CSFM Listed FM battery cabinet with charger for use with Autocall model and 4010ES addressable fire alarm control panels For mounting and charging of sealed lead acid batteries up to 110 Ah ordered separately Enclosure is a surface mounted red cabinet that mounts close nippled the control panel cabinet within 20 ft 6 m and connected with Models are available for operation at 120 VAC or 220 230 240 VAC charger details Charger provides dual rate operation with temperature compensation dynamic battery testing to detect for low voltage or missing battery Battery voltage charger voltage and current and charger status are all to the control panel and available for display Earth fault detection and depleted battery cutout are selectable UL listed to Standard 864 ULC listed to Standard S527 4100ES and 4010ES fire alarm control panels Use mounted within their enclosures For system applications additional battery backup these battery cabinets with battery accommodate batteries up to 110 Ah and control The control panel indicates status conditioned required battery cutout For ULC listed systems the low battery cutout disconnects the batteries when they reach low voltage cutoff selection 1 External battery cabinet with charger VAC Input input multi Compatible Battery Cabinet with for batteries up to 110 Ah 2 Battery reference ordered separately per Ah Sealed Battery 12 VDC 1 4100ES 4010ES battery cabinet with charger 2 batteries two required 24 V system exact appearance may vary reference 3 Additional reference Instructions Reference Battery Data Cabinet without charger for to 110 Ah Batteries This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7165 2269 0542 for allowable and or conditions concerning material presented in this document Additional listings may be applicable contact your local product supplier for the latest status Rev 7 07 2021 Compatible External Battery Cabinet with Charger 4100 Series and charger specifications Type Type and Capacity Output Voltage Standby Current Requirement Output Protection VAC Input Models VAC Input Models Range Range Connections from Control Panel Hardware and Cables 4 General specifications rate temperature compensated for batteries 55 Ah to 110 Ah Recharges batteries within 48 hours per UL Standard 864 and to 70 capacity in 12 per ULC Standard S527 lead acid Batteries are ordered separately VDC nominal mA A fast acting fuse Charger is reverse polarity protected 5 Input power requirements to 132 VAC 60 Hz A maximum to 264 VAC 50 60 Hz separate taps for 220 230 240 VAC A maximum 6 Environmental and mechanical Input Output to 122 0 C to 50 C to 93 RH non condensing 100.4 F 38 C maximum block for 14 to 12 AWG block for 14 to 6 AWG wire 5 terminals each for and ft 6 m maximum in conduit and cables to connect to 2081 9279 110 Ah batteries communications harness ft long 6 m battery connection harness to power distribution module PDM wire equivalents 14 AWG 2.08 mm2 12 AWG 3.31 mm 6 AWG 13.3 mm2 Battery specifications Voltage 7 Battery specifications Ah rating at 20 hour discharge rate V per battery 2 required for 24 V system current terminal posts in W x 9 in H x 10 1 2 in D 284 mm x 230 mm x 267 mm lbs 37 kg 2 Rev 7 07 2021 Compatible External Battery Cabinet with Charger 4100 Series dimension reference 3 dimension reference 3 Rev 7 07 2021 Compatible External Battery Cabinet with Charger 4100 Series 2021 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without notice listings may be applicable contact your local Autocall product supplier for the latest status Listings and approvals under Tyco Fire Security GmbH and the names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are registered of the National Fire Protection Association NFPA Rev 7 07 2021