Autocall A2084 FireFighter Cabinet Phone Assembly Installation Instructions

A2084 FireFighter Cabinet Phone Assembly Installation Instructions Warnings and Regulatory Information AND SAVE THESE INSTRUCTIONS Follow the instructions in this installation manual These instructions must be followed to avoid damage to product and associated equipment Product operation and reliability depend upon proper installation NOT INSTALL ANY AUTOCALL PRODUCT THAT APPEARS DAMAGED Upon unpacking your Autocall product inspect the of the carton for shipping damage If damage is apparent immediately file a claim with the carrier and notify an authorized product supplier HAZARD Disconnect electrical field power when making any internal adjustments or repairs All repairs should be by a representative or an authorized agent of your local Autocall product supplier HAZARD Static electricity can damage components Handle as follows Ground yourself before opening or installing components Prior to installation keep components wrapped in anti static material at all times FREQUENCY ENERGY This equipment has been tested and found to comply with the limits for a Class A digital device to part 15 of the FCC Rules These limits are designed to provide reasonable protection against harmful interference when equipment is operated in a commercial environment This equipment generates uses and can radiate radio frequency energy if not installed and used in accordance with the instruction manual may cause harmful interference to radio communications of this equipment in a residential area is likely to cause harmful interference in which case the user will be required to correct interference at his own expense REACCEPTANCE TEST AFTER SOFTWARE CHANGES To ensure proper system operation this product must be tested in with NFPA 72 after any programming operation or change in site specific software Reacceptance testing is required after change addition or deletion of system components or after any modification repair or adjustment to system hardware or wiring components circuits system operations or software functions known to be affected by a change must be 100 tested In addition ensure that other operations are not inadvertently affected at least 10 of initiating devices that are not directly affected by the up to a maximum of 50 devices must also be tested and proper system operation verified document describes the installation of the A2084 series Firefighter phone assembly models A2084 9001 A2084 9002 A2084 9003 A2084 9006 A2084 9008 A2084 9009 A2084 9014 A2084 9018 A2084 9021 A2084 9022 A2084 9024 into the phone back box A2975 9053 separately It is assumed that the phone back box is already installed Refer to publication Fire Fighter Phone System Installation Instructions for wiring and operation of the Firefighter phone systems Rev E Installing the A2084 Phone Assembly A2975 9053 1 Installing the A2084 Phone Assembly Place the A2084 Phone Assembly into the back box as shown Align the four holes on the mounting plate of the phone assembly with the threaded holes on the back box the mounting plate to the cabinet using 8 lockwashers and 8 32 x 1 4 screws Installing the Door Assembly 2 Installing the Door Assembly Place the door assembly over the box Open the door and locate the studs Place the lockwasher supplied over the stud so that it overlaps the box and secure it with the wing nut supplied Do not fully tighten When all four are in place center the door as required and tighten the wing nuts securely 2021 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without notice Additional listings may be applicable contact your local Autocall supplier for the latest status Listings and approvals under Tyco Fire Security GmbH and the product names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Alarm Code are registered trademarks of the National Fire Protection Association NFPA Rev E