Autocall A4081 Series End-of-Line Resistor Harnesses

UL ULC CSFM Listed use as Class B end of line resistor Connect these resistor harnesses where end of line resistors are at remote locations to monitor wiring continuity Refer to specific circuit specifications for end of line resistor Listed to Standard 864 Selection 1 Product Selection 5 tolerance except as noted k 1 2 W k 1 W k 1 2 W k 1 2 W k 1 2 W 1 W k 1 W k 1 2 W k 1 W 1 2 W k 1 2 W k 1 2 W 1 k 1 2 W k 1 W k 1 W Accessories Series End of Line Resistor Harnesses 1 A4081 Series Resistor Harness full size except for lead length This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7300 2269 0574 for allowable and or conditions concerning material presented in this document Additional listings may be applicable contact your local product supplier for the latest status Rev 2 01 2020 Series End of Line Resistor Harnesses Length Length Size Attachment 2 Specifications 9 1 2 241 mm 178 mm 1 25 mm AWG 0.82 mm2 V black 0.5 13 mm tinned leads are crimped to wires and covered with heat shrink tubing 2020 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without notice listings may be applicable contact your local Autocall product supplier for the latest status Listings and approvals under Tyco Fire Security GmbH and the names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are registered of the National Fire Protection Association NFPA Rev 2 01 2020