Autocall Battery Brackets for Seismic Activity Applications

UL ULC Approved secured battery mounting for geographical areas where activity is anticipated Available for use with compatible Autocall fire alarm control panel Series 4100ES 4010ES 4007ES 4009 IDNet NAC Extender TrueAlert Addressable Controller 4009T and 4009TPS Design was laboratory shake table tested and certified to resist the considered earthquake in the United States Install on site to either surface mount or flush mount backboxes see reference below One bracket holds two 2 compatible batteries Galvanized steel construction with insulation near battery terminals Refer to page 2 for selection information For additional information on seismically compliant equipment under State of California Statewide Office of Housing and Development Special Seismic Certification SSC program guidelines refer to Applications Guide 579 1213AC the following requirements IBC 2012 International Building Code CBC 2013 California Building Code ASCE 7 categories A F and all building heights Battery Mounting geographic regions where earthquake activity is a building design these battery brackets will hold the system batteries securely in Tested laboratory testing was performed to ensure these battery meet the requirements of ASCE 7 categories A through F per following IBC 2012 and CBC 2013 Certified ICC ES AC156 Testing Standard Importance Factor 1.5 the highest category Ss 3.73 G Sds 2.5 G z h 1.0 Accessories Brackets for Seismic Activity Applications 1 Battery Bracket Shown in a 2 Bay 4100ES Cabinet Reference Install bracket hardware into flush mounted boxes before installation for easier access Always mount boxes solidly Align mounting hardware with wall studs to the product box installation instructions for additional For additional battery bracket installation information refer to Instructions 579 944AC Additional listings may be applicable contact your local product supplier for the latest status 6 2015 Rev 4 Bracket Selection Reference No Batteries V sealed lead acid SKU 1 Selection reference Products Dimension Reference 18 Ah 4007ES 4010ES 33 Ah 1 2 or 3 Bay Cabinet 1 or 2 bay mm Note These brackets mount two of these 12 VDC batteries wired in series for 24 VDC systems Refer to data sheet AC2081 0006 for additional information Alternate batteries must be of identical dimensions mm x 133 mm x 171 mm mm mm x 86 mm x 168 mm W x 5 1 4 D x 6 3 4 H mm mm W x 3 3 8 D x 6 5 8 H Dimensions 1.5 mm Thick Shelf required when using 50 Ah batteries in 4100ES cabinets 2 Additional Battery Equipment 2018 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without notice listings may be applicable contact your local Autocall product supplier for the latest status Listings and approvals under Tyco Fire Security GmbH and the names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are registered of the National Fire Protection Association NFPA 6 2015 Rev 4