Autocall Building Network Interface Card (BNIC) Model A100-6047

Autocall ES Network ES Net Network Interface Card BNIC Model A100 6047 ULC CSFM Listed building network interface card BNIC module A100 6047 the following features Provides secured local area network LAN Ethernet connections for service access Compatible with Autocall 4100ES fire alarm control units FACUs on ES Network ES Net network Appears as an Ethernet switch to the building network and supports Ethernet connections Supports software downloads and uploads with LAN operation speed Allows execution of service level computer port commands Local access to LAN either by a technician service laptop PC or by a PC on site Download site specific software to multiple 4100ES FACUs equipped a BNIC module alarm network Upload site specific software from another 4100ES FACU on the same Authorized service personnel can log into the BNIC from remote or through the front FACU Ethernet connection on 4100ES 4 x 10 dual vertical block module size BNIC provides two external Ethernet ports to securely bridge the FACU with an external network such as the building network access to the external network and to any other 4100ES FACUs are on the external network functionality provides secure and authenticated communications perfomring the following functions Direct connection to the front FACU Ethernet service port External network connectivity with two external Ethernet port Execution of computer port commands to FACUs on the external Recovery of site specific programming details job files from a FACU on external network Net network application ES Net is a high bandwidth 100 Mbps IP based fire alarm network supports high speed FACU software downloads and uploads and execution of service level computer port commands over the fire network from any FACU location without the need for a BNIC In cases the need to connect to the building network with the BNIC no longer required on ES Net systems Contact your local Autocall supplier for additional information on ES Net products and 1 connection reference This product has been approved by the California State Fire Marshal CSFM pursuant to Section 13144.1 of the California Health and Safety Code See CSFM Listing 7165 2269 0542 for allowable and or conditions concerning material presented in this document Additional listings may be applicable contact your local Autocall product supplier for the latest status See product for models that are UL Listed Rev 7 2 2021 product selection compatibility with dual Ethernet ports block usage current vertical blocks 1 max mA 1 BNIC product selection Network Interface Card BNIC Model A100 6047 diagnostics 2 Specifications on board status LEDs size range instructions status status status fault vertical block 4 x 10 module to 120 0 to 49 to 93 RH at 90 32 includes an MIS IT configuration data sheet reference basic FACUs with SPS power supplies Net products and specifications basic FACUs with EPS power supplies 3 Additional data sheet reference sheet 2021 Johnson Controls All rights reserved All specifications and other information shown were current as of document revision and are subject to change without notice listings may be applicable contact your local Autocall product supplier for the latest status Listings and approvals under Tyco Fire Security GmbH and the names listed in this material are marks and or registered marks Unauthorized use is strictly prohibited NFPA 72 and National Fire Alarm Code are registered of the National Fire Protection Association NFPA Rev 7 2 2021