Autocall System Batteries, Sealed Lead-Acid; with Applications Reference for Battery Cabinets, and Battery Cabinets with Charger

Listings Alarm Control Panel Accessories Batteries Sealed Lead Acid with Applications Reference for Battery Cabinets and Cabinets with Charger sealed lead acid batteries Lead calcium grid structure with immobilized electrolyte in absorbent Low maintenance with no need to add water Low self discharge characteristics One piece high impact polystyrene cell cover with high reliability dual construction UL 924 recognized pressure relief valves in a variety of capacities Batteries for internal mounting range from 6.2 Ah to 50 Ah depending control panel cabinet size Larger batteries up to 110 Ah mount in external battery cabinets with available with internal chargers cabinets with chargers Battery cabinets with charger communicate with their connected fire control panel and are available for 4100ES 4010ES Series panels rechargeable sealed lead acid batteries provide reliable and discharge and recharge characteristics for use in fire alarm other systems applications They are designed with immobilized in an absorbent separator allowing them to provide rated on the first cycle of their sealed construction packaging is possible within the electronics enclosure see Figure 3 When this is applicable quantity of system cabinets and the battery wiring distances are Where required external battery cabinets can be close to the control panel to house larger batteries with battery available in some battery cabinet sizes details These batteries are for use with compatible Autocall battery connections Connect the batteries in series to produce 24 V voltage Battery sets must be of identical voltage model number and approximately the same date of manufacture for operation Perform battery capacity testing by using a sealed lead acid tester to withdraw a minimum of battery charge Testing is through your local Autocall product supplier Sealed lead acid batteries are shipped via ground or sea only They are not shipped via air Battery chemicals and materials can be recycled Refer to shipped with the battery or on its case Return to the or to a similarly qualified battery processing facility for disposal activity applications Battery brackets are available for tested for compliance with specific batteries Refer to data AC2081 0019 for details 1 sealed lead acid batteries can installed inside fire alarm control panel cabinets 2 battery cabinets are for larger battery requirements See product information on page 4 for applicable agency listings at the time of publication Additional listings may be applicable contact your local product supplier for the latest status Rev 24 08 2020 Batteries Sealed Lead Acid with Applications Reference for Battery Cabinets and Battery Cabinets with Charger construction reference appearance will vary with battery size 3 contruction reference size specifications Model 20 Hour Rate Weight with Ah in 102 mm in 86 mm in 156 mm in 153 mm in 153 mm in 184 mm in 168 mm Ah Ah Ah Ah Ah in 67 mm in 103 mm in 102 mm in 102 mm in 102 mm rectangular typically for square use for new lb 19 kg lb 37 kg Dimensions and weight are per battery and are for reference only Exact size may vary Refer to Battery compatibility for fire alarm control panel and External battery cabinet compatibility reference for mounting compatibility Batteries are 12 V each and connected in series for 24 V use When wired in series for 24 V output these batteries are to be of identical voltage appearance model number and approximately the same of manufacture lb 2.6 kg lb 4.2 kg lb 4.1 kg in 140 mm in 267 mm lb 6.5 kg lb 8.8 kg in 179 mm in 284 mm in 168 mm in 225 mm in 318 mm in 197 mm in 171 mm in 133 mm in 86 mm lb 12.1 kg Ah Ah in 229 mm in 230 mm in 127 mm in 178 mm lb 12 kg Ah battery specifications Voltage Rating Rating Charge Discharge Cycles Charge Temperature Range V hour rate cycles to 150 cycles to 90 15.6 to 32.2 2 Rev 24 08 2020 Batteries Sealed Lead Acid with Applications Reference for Battery Cabinets and Battery Cabinets with Charger compatibility for fire alarm control panel mounting Refer to individual fire alarm control panel product data sheets for additional battery application information 1 Battery compatibility for fire alarm control panel mounting Control Panel Model Series see legend and notes below Model rectangular square or 3 bay external battery cabinet compatible with 4100ES 4010ES Series only Can be placed in the respective equipment cabinet External battery cabinet is required refer to selection chart on page 4 Not applicable not compatible These batteries meet the requirements of UL ULC for use with respective equipment battery chargers listed above Contact your local Autocall Ah Ah Ah Ah Ah Ah Ah Ah Ah all 2 supplier for proper battery selection per system requirements For 2 bay cabinets only 50 Ah batteries will fit in the cabinet battery cabinet compatibility reference cabinets without chargers connects to charger in panel Ah 4010ES N A cabinets with chargers Ah Ah 4010ES N A Batteries smaller than those listed are normally mounted in the product cabinet 25 AH capacity is effective as of 7 2005 Can be placed in the respective equipment cabinet Not applicable not compatible 2 External battery cabinet compatibility reference Ah Ah Ah Ah Ah 3 External battery cabinet compatibility reference Ah Ah Ah Ah 3 Rev 24 08 2020 Batteries Sealed Lead Acid with Applications Reference for Battery Cabinets and Battery Cabinets with Charger battery cabinet specification reference 4 Battery cabinets without chargers shallow design with front door 4100 style cabinet without charger with locking solid door battery shelf primarily for use with 50 Ah batteries ULC FM For up to 25 Ah battery cabinet without charger with solid door and battery harness for mounting to fire alarm control cabinet 3 4 in W x 20 3 4 in H x 6 3 4 in D mm x 527 mm x 171 mm 1 4 in W x 13 1 2 in H x 5 3 4 in D mm x 343 mm x 146 mm 5 Battery Cabinet Without Charger for 110 Ah Batteries for use with compatible panel mounted chargers refer to data sheet AC2081 0012 and Listing CSFM 1 2 in W x 12 H x 12 in D 673 x 305 mm x 305 cabinet for 110 Ah includes A battery fuse and connection see data for details Series Series Main System MSS Main System II MSS2 System Supplies SPS Additional Remote Supply RPS TrueAlert Power TPS 6 Battery cabinet without charger for 110 Ah batteries for use with compatible panel