DSC 3G30XX-3G3070 upgrade instructions

File Preview
File Preview
Click below to download for free

File Data

Name dsc-3g30xx-3g3070-upgrade-instructions-5849206173.pdf
Type PDF
Size 1.53 MB
Downloads

Text Preview

GS3055 60 2G to 3G3070 3G PCB Replacement Guide instructions must be used in conjunction with the 3G3070 Installation Manual Observe all specified safety precau during the board replacement The 3G3070 GS3055 60 PCB must be replaced by service persons only Completely power down the GS3055 60 by removing power to the 12V input terminal and disconnecting the battery red and black wires Disconnect the telecommunications network wiring and any connection to the other terminals Carefully disconnect the GSM antenna from the GSM radio module on the GS3055 60 To remove the cable from the module insert a small flat head screwdriver between the antenna connector cable and the radio module see fig 1 and 2 then gently pry the plug loose Make sure that the screwdriver does not slip off Any other method for removal of the antenna may cause permanent damage to the on board connector or antenna cable Figure 1 Figure 2 The GS3055 60 PCB is secured by screws and or plastic standoffs located at the four corners of the board Carefully the top of each standoff to release the PCB from the standoff Needle nose pliers are recommended a standoff breaks the cabinet may have to be unfastened from the wall to remove the broken part Extra standoffs are with the replacement PCB Once the old PCB is removed from the cabinet carefully remove the SIM card from the PCB Slide the SIM card holder the left in the direction labeled OPEN on the SIM card holder the SIM card into the 3G3070 PCB The notch on the SIM card should face towards the LEDs Once the card is seated in the connector press down and slide it into the LOCK position as indicated on the SIM card holder Mount the 3G3070 PCB back into the cabinet To mount align the standoff holes and tighten the screws that were from step 4 if applicable When mounting the PCB onto the standoffs only apply pressure to the corners of PCB next to the standoff mounting hole Do not apply pressure to the center of the PCB or any of the components Reconnect all the wiring to the terminals removed in step 2 except power i e do not attach the battery or apply power to 12V terminal the unit was previously installed in non current limited mode i e GS3055 ICF please ensure jumper JP3 is to the ON position on the 3G3070 PCB When upgrading from a GS30XX to 3G3070 communicator replace the information label on the inside of the cabinet and approvals label on the outside of the cabinet Match the model number of the current GS30XX communicator with its 3G3070 replacement GS3060 GS3055 ICF GS3060 RF From labels provided select the information label with matching model number and place over the information label to the inside of the cabinet completely covering the old label From the labels provided select the corresponding label and apply covering the top half of the approvals label see figure 3 located on the outside of the cabinet bottom half contains the manufacturer name UL and ULC marks and must remain visible Figure 3 order to remain compliant with regulatory approvals you must replace the labels Perform a hardware default on the unit by following these steps Ensure the unit is still powered down Connect a wire between PGM1 terminal 7 and Z1 terminal 15 Power up the radio by connecting the battery first and then primary DC power Wait for 40 seconds and then completely power down the unit Disconnect the wire between the PGM1 and Z1 terminals hardware default must be performed when the SIM card is being replaced red and yellow LEDs will flash indicating the unit is establishing a connection to get its programming from the network may take several minutes Please refer to the 3G3070 Installation Manual if the red LED starts to flash on its own Tyco International Ltd and its Respective Companies All Rights Reserved Support 1 800 387 3630 Canada U S or 905 760 3000 Canada www dsc com Printed in Canada

Related Files