DSC AMB-300 DSC Addressable Passive Infrared Detectors

DSC Addressable Passive Infrared Detectors addressable passive infrared detector AMB employs a large multi beam lens design Multi Level Signal Processing MLSP temperature compensation to ensure human are identified To ensure trouble free operation many years special attention is given to false alarm against RF static and electrical transients The uses a two wire connection to the control that helps to reduce installation time and cost The current draw of the detector helps maximize the of devices that can be attached to an loop Features lens design Multi Level Signal Processing MLSP for detection of human IR energy over a broad of temperatures element low noise sensor static and transient protection white light immunity RF immunity catch performance at elevated temperatures on off jumper interchangeable lenses available wall mount and ceiling mount brackets available modern design your DSC distributor Addressable Passive Infrared Detectors Pattern the Detector choosing a location for the detector be sure to consider following Do not aim the detector at reflective surfaces Avoid locations that are subject to direct high air flow Do not locate the detector in the path of direct or sunlight Do not place next to large obstructions that may limit the area Detection Multi Level Signal Processing MLSP provides for more detection of human IR energy over a broad range of It able to maximize catch performance while protection against false alarm sources such as radio air vents and insects Lenses standard lens is the wall to wall lens BV L1 Additional lens the corridor lens BV L2 curtain lens BV L3 and the pet lens BV L4 To change any of the lenses release the tab and the lens holder out This action releases the lens Insert the lens with the grooves facing inward The bottom of the lens is by two triangular indentations Ensure that the lens is and then reattach the lens holder The lens holder will into place sealing the lens into position Information Addressable Passive Infrared Detector Wall to Wall Lens Corridor Lens Curtain Lens Pet Alley Lens Wall Mount Bracket Ceiling Mount Bracket by 3.5 H x 2.5 W x 1.87 D 89 mm x 64 mm x 48 mm Voltage 9 to 14 V RMS Current 2.5 mA in Alarm 2.5 mA Current 5.0 mA Rating 100 mA 24 VDC Temperature Range 32 to 122 F 0 to 50 C Immunity 0 V m from 0.01 to 1,200 MHz Humidity 5 to 95 Immunity 25 kV Immunity 2.4 kV 1.2 joules Light Immunity 20,000 Lux Device Detection Speed 0.5 to 10 ft s 0.15 to 3 m sec Duration 2 to 3 Seconds Angle BV L1 90 Minimum Adjustment 5 to 10 Heights BV L1 L2 L3 6 to 10.5 ft 1.8 to 3.2 m BV L4 4 to 5 ft 1.2 to 1.5 m Compatible with DSC AML Addressable Multiplex Loop voltage product information specifications and availability subject to without notice Certain product names herein may be trade names and or trademarks of other companies 2005 ViewWall to Wall Pet Alley Lens50 15.2mSide View10 3m50 15.2mWall to Wall Lens10 3m10 3mSide View10 3m50 15.2m10 3mPet Alley LensSide View10 3m50 15.2mTop ViewCurtain Lens4.4 1.3m10 3mTop ViewCorridor Lens10.5 3.2m10 3m80 24.6mSide View10 3m10 3m80 24.6mfirealarmresources com