DSC AMB-500 DSC Addressable Ceiling-Mount Motion Detectors

DSC Addressable Ceiling Mount Detectors motion detection is dependent on a ability to identify intruders and provide false alarm resistance The addressable ceiling motion detector AMB 500 achieves superior through a special fresnel lens made for 360 and a quad element PIR sensor optimized for detection all around its field of view To ensure operation for many years special attention given to false alarm immunity against RF static and transients The detector uses a two wire to the control panel that helps to reduce time and cost The low current draw of the helps maximize the number of devices that can attached to an addressable loop Features element low noise PIR sensor Multi Level Signal Processing MLSP accurate detection of human IR energy over a range of temperatures detection range static and transient protection RF EM immunity adjustment to configure the detector for sensitivity or low sensitivity environments switch plastic enclosure complements any d your DSC distributor Addressable Ceiling Mount Detectors Pattern the Detector choosing a location for the detector be sure to consider following Do not aim the detector at reflective surfaces Avoid locations that are subject to direct high air flow Do not locate the detector near sources of moisture Do not locate the detector in the path of direct or sunlight Do not place next to large obstructions that may limit the area Detection Multi Level Signal Processing MLSP provides for more detection of human IR energy over a broad range of It able to maximize catch performance while protection against false alarm sources such as radio air vents and insects Adjustment sensitivity of the detector can be adjusted between fast and detection modes In a normal operating environment the best operates in the fast mode In environments where air movement heaters and other environmental variables problems use the slow detection mode The detector is for the fast detection mode Information Addressable Ceiling Mount Motion Detector by 4.6 x 1.4 H mm x 36mm Voltage 9 V RMS to 14 V RMS Current 2.5 mA in Alarm 2.5 mA Current 5.0 mA Rating 100 mA 24 VDC Temperature Range 32 to 120 F 0 to 49 C Immunity 50 V m from 0.01 to 1,200 MHz Humidity 5 to 95 Immunity 25 kV Immunity 2.4 kV 1.2 joules Detection Speed 0.5 to 10 ft s 0.15 to 3 m sec Compatible with DSC AML Addressable Loop voltage product information specifications and availability subject to without notice Certain product names herein may be trade names and or trademarks of other companies 2005 4.6m15 4.6mTop View360 Element PIR height5 1.5m5 LensBottom LensMiddle LensSide View20