DSC AMP 700 IS EN NA

FCC COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Controls Ltd void your authority to use this equipment equipment generates and uses radio frequency energy and if not installed and used properly in accordance with the manufacturer instructions may cause interference to radio and televi reception It has been type tested and found to comply with the limits for Class B device in with the specifications in Subpart of Part 15 of FCC Rules which are designed to reasonable protection against such interference in any residential installation However is no guarantee that interference will not occur in a particular installation If this equipment cause interference to television or radio reception which can be determined by turning the off and on the user is encouraged to try to correct the interference by one or more of the measures Re orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control and receiver are on different necessary the user should consult the dealer or an experienced radio television technician additional suggestions The user may find the following booklet prepared by the FCC to Identify and Resolve Radio Television Interference Problems This booklet available from the U S Government Printing Office Washington D C 20402 Stock Warranty Security Controls Ltd warrants that for a period of twelve months from the of purchase the product shall be free of defects in material and workmanship normal use and that in fulfillment of any breach of such warranty Digital Controls Ltd shall at its option repair or replace the defective equipment return of the equipment to its repair depot This warranty applies only to in parts and workmanship and not to damage incurred in shipping or or damage due to causes beyond control of Digital Security Controls Ltd as lightning excessive voltage mechanical shock water damage or damage out of abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in of any and all other warranties whether express or implied and of all other or liabilities on the part of Digital Security Controls Ltd This warranty the entire warranty Digital Security Controls Ltd neither assumes nor any other person purporting to act on its behalf to modify or to change this nor to assume for it any other warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or damages loss of anticipated profits loss of time or any other losses by the buyer in connection with the purchase installation or operation or of this product Security Controls Ltd recommends that the entire system be completely on a regular basis However despite frequent testing and due to but not to criminal tampering or electrical disruption it is possible for this product fail to perform as expected 1998 Digital Security Controls Ltd Flint Road Downsview Ontario Canada M3J 2J6 416 665 8460 Fax 416 665 7498 in Canada 29003072 R0 Magnetic Door Window Contact INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS AMP 700 contact uses a 2 wire connection for power and to with the control panel This in combination with low power simplifies wiring and reduces device count for fast and efficient AMP 700 has a magnetic contact and an internal tamper switch so as monitor both the alarm and tamper states Rating 0.8mA Environment 0 49 32 120 95 RH non condensing H x W x D 27 x 85 x 19mm 11 16 x 33 8 x 3 4 in Panel Compatibility v3.0 Diagram the connection wires through the wiring holes on the back of the unit mount the unit remove the plastic cover and secure the unit to the location with the screws provided Replace the cover the magnet next to the reed switch as shown in the diagram Enrollment serial number located on the back of the device must be enrolled into the control panel via Installer Programming Q 8 Installer Code procedure is outlined for the PC4010 4020 v3.0 in the control panel Manual Connect only DSC Addressable Series devices to the loop connections Connection of ANY other type of device will operation Any devices other than Addressable Series devices require power to operate must be powered separately