DSC AMP - 701 Addressable Contact Input Module - Install Manual

FCC COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Controls could void authority to use this equipment equipment generates and uses radio frequency energy and if not installed and used properly in accordance with the manufacturer instructions may cause interference to radio and television It has been type tested and found to comply with the limits for Class B device in accordance the specifications in Subpart of Part 15 of FCC Rules which are designed to provide protection against such interference in any residential installation However there is no that interference will not occur in a particular installation If this equipment does cause to television or radio reception which can be determined by turning the equipment off and the user is encouraged to try to correct the interference by one or more of the following measures Re orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control and receiver are on different necessary the user should consult the dealer or an experienced radio television technician additional suggestions The user may find the following booklet prepared by the FCC to Identify and Resolve Radio Television Interference Problems This booklet available from the U S Government Printing Office Washington D C 20402 Stock Warranty Security Controls warrants that for a period of twelve months from the date of purchase product shall be free of defects in material and workmanship under normal use and that in of any breach of such warranty Digital Security Controls shall at its option repair replace the defective equipment upon return of the equipment to its repair depot This applies only to defects in parts and workmanship and not to damage incurred in or handling or damage due to causes beyond control of Digital Security Controls such lightning excessive voltage mechanical shock water damage or damage arising out of alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any all other warranties whether express or implied and of all other obligations or liabilities on part of Digital Security Controls This warranty contains the entire warranty Digital Controls neither assumes nor authorizes any other person purporting to act on its behalf modify or to change this warranty nor to assume for it any other warranty or liability this product no event shall Digital Security Controls be liable for any direct indirect or consequential loss of anticipated profits loss of time or any other losses incurred by the buyer in with the purchase installation or operation or failure of this product Security Controls recommends that the entire system be completely tested on a regular However despite frequent testing and due to but not limited to criminal tampering or disruption it is possible for this product to fail to perform as expected Digital Security Controls Canada cid 129 www dsc com Support 1 800 387 3630 Canada U S or 905 760 3036 in Canada Contact Input Module INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS INSTRUCTIONS AMP 701 contact uses a 2 wire connection for power and to with the control panel This simplifies wiring and reduces cost The AMP 701 low current draw also maximizes the of devices that can be attached to an addressable loop AMP 701 has three alarm input terminals to which an external device be connected The terminals monitor alarm tamper and trouble states only devices with NC dry contact outputs The use of any other type of will impair the operation of the AMP 701 Rating 0.8mA Environment 0 49 32 120 5 95 RH non condensing H x W x D 27 x 85 x 19mm 11 16 x 33 8 x 3 4 in Panel Compatibility v3 x v2 x with PC5100 interface module Diagram the connection wires through the wiring holes on the back of the unit Enrollment mount the unit remove the plastic cover and secure the unit to the location with the screws provided Replace the cover serial number located on the back of the device must be enrolled into the control panel via Installer Programming 8 Installer Code This is outlined for the PC4010 4020 in the control panel Installation and for the Power panels in the PC5100 Installation Manual WARNING cid 129 only DSC Addressable Series devices to the addressable loop Connection of ANY other type of device will impair Any devices other than Addressable Series devices which power to operate must be powered separately