DSC AMP-701NP - Addressable Contact Input Module - Installation Manual - En - Ch

AMP 701NP Contact Input Module Instructions AMP 701NP contact uses a 2 wire connection for power and to communicate with control panel This simplifies wiring and reduces installation cost The low current of AMP 701NP also maximizes the number of devices that can be attached to an loop AMP 701NP has three alarm input wires to which an external device can be con The wires monitor alarm tamper and trouble states Use only devices with NC contact outputs The use of any other type of device will impair the operation of the Current Rating 0.8mA Operating Environment 49 32 120 95 RH non condensing Panel Compatibility 4020 v3 x PC5010 5015 v2 x with PC5100 interface module PC5020 V3.2 with PC5100 interface module Diagram Enrollment Number serial number located on the front of the device must be enrolled into the alarm panel via Installer Programming 8 Installer Code This procedure is for the PC4020 in the control panel Installation Manual and for the Power in the PC5100 Installation Manual WARNING cid 129 only DSC Addressable Series devices to the addressable loop Connection of ANY other type of device will impair opera Any devices other than Addressable Series devices which require to operate must be powered separately manual shall be used in conjunction with the Installation Manual of the alarm con panel All the instructions specified within that manual must be observed READ CAREFULLY DSC Software purchased with or without Products and Components copyrighted and is purchased under the following license terms Warranty Security Controls warrants that for a period of 12 months from the date of the product shall be free of defects in materials and workmanship under use and that in fulfilment of any breach of such warranty Digital Security shall at its option repair or replace the defective equipment upon return the equipment to its repair depot This warranty applies only to defects in parts workmanship and not to damage incurred in shipping or handling or damage to causes beyond the control of Digital Security Controls such as lightning voltage mechanical shock water damage or damage arising out of alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in of any and all other warranties whether expressed or implied and of all other or liabilities on the part of Digital Security Controls Digital Security neither assumes responsibility for nor authorizes any other person pur This End User License Agreement is a legal agreement between You the com individual or entity who acquired the Software and any related Hardware and Digital Controls a division of Tyco Safety Products Canada Ltd the manufacturer the integrated security systems and the developer of the software and any related prod or components which You acquired If the DSC software product PRODUCT or is intended to be by HARDWARE and is NOT accompanied by new HARDWARE You may use copy or install the SOFTWARE PRODUCT The SOFTWARE PRODUCT includes software and may include associated media printed materials and or documentation Any software provided along with the SOFTWARE PRODUCT that is associated with a sep end user license agreement is licensed to You under the terms of that license agree INSTALLING COPYING DOWNLOADING STORING ACCESSING OR OTHERWISE USING SOFTWARE PRODUCT YOU AGREE UNCONDITIONALLY TO BE BOUND BY THE TERMS THIS EULA EVEN IF THIS EULA IS DEEMED TO BE A MODIFICATION OF ANY PREVIOUS OR CONTRACT IF YOU DO NOT AGREE TO THE TERMS OF THIS EULA DSC UNWILLING TO LICENSE THE SOFTWARE PRODUCT TO YOU AND YOU HAVE NO RIGHT USE IT PRODUCT LICENSE SOFTWARE PRODUCT is protected by copyright laws and international copyright as well as other intellectual property laws and treaties The SOFTWARE is licensed not sold GRANT OF LICENSE This EULA grants You the following rights Software Installation and Use For each license You acquire You may have only one copy of SOFTWARE PRODUCT installed Storage Network Use The SOFTWARE PRODUCT may not be installed accessed displayed shared or used concurrently on or from different computers including a workstation or other digital electronic device In other words if You have several You will have to acquire a license for each workstation where the SOFTWARE be used Backup Copy You may make back up copies of the SOFTWARE PRODUCT but may only have one copy per license installed at any given time You may use back up copy solely for archival purposes Except as expressly provided in this You may not otherwise make copies of the SOFTWARE PRODUCT including printed materials accompanying the SOFTWARE DESCRIPTION OF OTHER RIGHTS AND LIMITATIONS Limitations on Reverse Engineering Decompilation and Disassembly You may not engineer decompile or disassemble the SOFTWARE PRODUCT except and to the extent that such activity is expressly permitted by applicable law this limitation You may not make any changes or modifications to Software without the written permission of an officer of DSC You may not any proprietary notices marks or labels from the Software Product You shall reasonable measures to ensure compliance with the terms and conditions of EULA Separation of Components The SOFTWARE PRODUCT is licensed as a single product Its parts may not be separated for use on more than one HARDWARE unit Single INTEGRATED PRODUCT If You acquired this SOFTWARE with HARDWARE then the PRODUCT is licensed with the HARDWARE as a single integrated product In this the SOFTWARE PRODUCT may only be used with the HARDWARE as set forth in this Rental You may not rent lease or lend the SOFTWARE PRODUCT You may not it available to others or post it on a server or web site Software Product Transfer You may transfer all of Your rights under this EULA only as part of permanent sale or transfer of the HARDWARE provided You retain no copies You transfer all the SOFTWARE PRODUCT including all component parts the media and printed any upgrades and this EULA and provided the recipient agrees to the terms of this If the SOFTWARE PRODUCT is an upgrade any transfer must also include all prior of the SOFTWARE PRODUCT Without prejudice to any other rights DSC may terminate this EULA if You fail to with the terms and conditions of this EULA In such event You must destroy all copies the SOFTWARE PRODUCT and all of its component parts to act on its behalf to modify or to change this warranty nor to assume for any other warranty or liability concerning this product no event shall Digital Security Controls be liable for any direct indirect or con damages loss of anticipated profits loss of time or any other losses by the buyer in connection with the purchase installation or operation or of this product Digital Security Controls recommends that the entire system be com tested on a regular basis However despite frequent testing and due to not limited to criminal tampering or electrical disruption it is possible for this to fail to perform as expected INFORMATION Changes or modifications not expressly approved Digital Security Controls could void the user authority to operate this equip Trademarks This EULA does not grant You any rights in connection with any trademarks or marks of DSC or its suppliers BUT NOT LIMITED TO ANY COPYRIGHT ALL TITLE AND INTELLECTUAL PROPERTY RIGHTS IN AND TO THE PRODUCT AND TEXT INCORPORATED INTO THE SOFTWARE PRODUCT THE PRINTED MATERIALS AND ANY COPIES OF THE SOFTWARE ARE OWNED BY DSC OR ITS SUPPLIERS YOU MAY NOT COPY THE MATERIALS ACCOMPANYING THE SOFTWARE PRODUCT ALL TITLE AND PROPERTY RIGHTS IN AND TO THE CONTENT WHICH MAY BE THROUGH USE OF THE SOFTWARE PRODUCT ARE THE PROPERTY OF RESPECTIVE CONTENT OWNER AND MAY BE PROTECTED BY APPLICABLE OR OTHER INTELLECTUAL PROPERTY LAWS AND TREATIES THIS EULA YOU NO RIGHTS TO USE SUCH CONTENT ALL RIGHTS NOT EXPRESSLY UNDER THIS EULA ARE RESERVED BY DSC AND ITS SUPPLIERS EXPORT RESTRICTIONS YOU AGREE THAT YOU WILL NOT EXPORT OR THE SOFTWARE PRODUCT TO ANY COUNTRY PERSON