DSC DLM-4L - Installation Manual - English - Downlook Video Transmitter Module

DLM 4L Downlook Still Frame Video Module Version 1.0L INSTALLATION INSTRUCTIONS 4 image storage Camera supervision Compatible control panel PC5015 v2.2 with PC5108L Interface 10.5 16.0VDC 180mA 12VDC Output of 5108L Transmits one frame in approximately 10 to 12 seconds the Panel system should be installed and serviced by qualified security the DLM 4L is to be used with a security system install and test the system according to the manufacturer instructions For install the DLM 4L module close to the security system s panel Remove the printed circuit board and mounting hardware from the packaging It is recommended that the DLM 4L be in its own cabinet with the 5108L attaching the cabinet to the wall press the four nylon studs into the raised mounting holes from the back of cabinet the cabinet securely to the wall Use appropriate wall with PC5108L Hook up Diagram when securing the panel to drywall plaster concrete or other similar surfaces Press the DLM 4L onto the four mounting studs Requirements DLM 4L v1.0L is used with the PC5108L Video Switcher Zone Interface Module Refer to the hook up diagram below power connections Connections to the hook up diagram below for terminal connections Connection video source for the DLM 4L is provided by the output of the If another device such as a VCR or monitor is connected to output of the 5108L then take the output of the device or T tap video connection to provide the necessary video connection to DLM 4L cameras should be installed prior to connection of the DLM 4L PC5108L Correct installation alignment and lens will provide maximum results on the Downlook system more information regarding Downlook operation programming testing see the PC5108L Installation Manual Switch Settings are 8 dip switches that must be set in the OFF position WARRANTY Security Controls Ltd warrants that for a period of twelve months from the date of purchase the product shall be free of defect in materials and workmanship under normal and that in fulfilment of any breach of such warranty Digital Security Controls Ltd shall at its option repair or replace the defective equipment upon return of the equipment its repair depot This warranty applies only to defects in parts and workmanship and not to damage incurred in shipping or handling or damage due to causes beyond the control Digital Security Controls Ltd such as lightning excessive voltage mechanical shock water damage or damage arising out of abuse alteration or improper application of the foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other warranties whether expressed or implied and of all other obligations or liabilities the part of Digital Security Controls Ltd This warranty contains the entire warranty Digital Security Controls Ltd neither assumes nor authorizes any other person purporting to on its behalf to modify or to change this warranty nor to assume for it any other warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages loss of anticipated profits loss of time or any other losses incurred by the in connection with the purchase installation or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be completely tested on a regular basis However despite frequent testing and due to but not limited criminal tampering or electrical disruption it is possible for this product to fail to perform as expected COMPLIANCE Changes or modifications not expressly approved by Digital Security Controls Ltd could void your authority to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits are to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radiate radio energy and if not installed and used in accordance with the instructions may cause harmful interference to radio communications However is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful interference to radio or television which can be determined by turning the equipment off and on the user is encouraged to try to correct the interference by one or more of the measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Resolve Radio Television Interference Problems This booklet available from the U S Government Printing Office Washington D C 20402 Stock 004 000 00345 4 Information equipment complies with Part 68 of the FCC Rules On the side of this equipment is a label that contains among other information the FCC registration of this equipment to Telephone Company Upon request the customer shall notify the telephone company of the particular line to which the connection will made and provide the FCC registration number and the ringer equivalence of the protective circuit Registration Number F53CAN 32103 DM N Interface Code N A Connection Requirements Except for the telephone company provided ringers all connections to the telephone network shall be made through plugs and telephone company provided jacks or equivalent in such a manner as to allow for easy immediate disconnection the terminal equipment Standard jacks shall be so arranged that if the plug connected thereto is withdrawn no interference to the operation of the at the customer premises which remains connected to the telephone network shall occur by reason of such withdrawal of Harm Should terminal equipment or protective circuitry cause harm to the telephone network the telephone company shall where notify the customer that temporary disconnection of service may be required however where prior notice is not practicable the telephone may temporarily discontinue service if such action is deemed reasonable in the circumstances In the case of such temporary discontinuance telephone company shall promptly notify the customer and will be given the opportunity to correct the situation Telephone Company Information The security control panel must be properly connected to the telephone line with a USOC RJ 31X telephone The FCC prohibits customer provided terminal equipment be connected to party lines or to be used in conjunction with coin telephone service rules may vary from state to state in Telephone Company Equipment of Facilities The telephone company may make changes in its communications facilities equipment or procedures where such actions are reasonably required and proper in its business Should any such changes render the customer terminal incompatible with the telephone company facilities the customer shall be given adequate notice to the effect modifications to maintain service Equivalence Number REN The REN is useful to determine the quantity of devices that you may connect to your telephone line and still have of those devices ring when your telephone number is called In most but not all areas the sum of the RENs of all devices connected to one line should exceed five 5.0 To be certain of the number of devices that you may connect to your line you may want to contact your local telephone company Maintenance Facility If you experience trouble with this telephone equipment please contact the facility indicated below for information obtaining service or repairs The telephone company may ask that you disconnect this equipment from the network until the problem has been corrected until you are sure that the equipment is not malfunctioning Security Controls Ltd 160 Washburn Street Lockport NY 14094 Equivalence Number 0.4B Order Code N A Jack RJ 11C 1998 Sur Gard Security Systems Ltd Magnetic Drive Unit 24 28 Downsview Ontario Canada M3J 3H9 1 800 418 7618 Tech