DSC EKT-824 - Installation Manual - English - Communique Telephone Handset

LIMITED WARRANTY Security Controls Ltd warrants that for a period of twelve months from the date of the product shall be free of defect in materials and workmanship under normal and that in fulfilment of any breach of such warranty Digital Security Controls Ltd shall its option repair or replace the defective equipment upon return of the equipment to its depot This warranty applies only to defects in parts and workmanship and not to incurred in shipping or handling or damage due to causes beyond the control of Security Controls Ltd such as lightning excessive voltage mechanical shock water or damage arising out of abuse alteration or improper application of the foregoing warranty shall apply only to the original buyer and is and shall be in lieu of and all other warranties whether expressed or implied and of all other obligations or on the part of Digital Security Controls Ltd This warranty contains the entire Digital Security Controls Ltd neither assumes nor authorizes any other person to act on its behalf to modify or to change this warranty nor to assume for it any warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or damages loss of anticipated profits loss of time or any other losses incurred the buyer in connection with the purchase installation or operation or failure of this Digital Security Controls Ltd recommends that the entire system be tested on a regular basis However despite frequent testing and due to but limited to criminal tampering or electrical disruption it is possible for this product to fail perform as expected COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Products Ltd void your authority to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device to Part 15 of the FCC Rules These limits are designed to provide reasonable protection harmful interference in a residential installation This equipment generates uses and can radio frequency energy and if not installed and used in accordance with the instructions cause harmful interference to radio communications However there is no guarantee that will not occur in a particular installation If this equipment does cause harmful to radio or television reception which can be determined by turning the equipment and on the user is encouraged to try to correct the interference by one or more of the measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Radio Television Interference Problems This booklet is available from the U S Printing Office Washington D C 20402 Stock 004 000 00345 4 Security Products Ltd 160 Washburn St Lockport NY 14094 Digital Security Controls Ltd Flint Road Downsview Ontario Canada M3J 2J6 665 8460 1 800 387 3630 in Canada 29002355 R0 Set Instructions Communiqu telephone set can be placed on any flat surface or mounted on wall the telephone is going to rest on a flat surface snap the mounting bracket see into place in the top position on the back of the telephone unit mount the telephone unit on a wall perform the following Snap the mounting bracket into place in the bottom position on the back of telephone unit Locate the area upon which the telephone is to be mounted Fasten the two screws to the wall Ensure that they are the same distance apart as mounting holes on the back of the telephone set Place the telephone unit over the screws and then press it down towards the to secure it into place see diagram below Once the telephone set is mounted to the wall the wire connection must be Using the provided connecting cable plug one end into the back of telephone and the other end into the desired station port on the system