DSC ESCORT5580 v1 1 - Installation Manual - English - PowerSeries Telephone Interface & Automation Control Module

Installation 2002 Digital Security Controls Ltd Canada cid 127 www dsc com Support 1 800 387 3630 in Canada 29002044 R2 1.1 L de l Canada identifie le mat homologu Cette certifie que le mat est conforme certaines de protection d et de s des r de t Industrie Canada n toutefois pas que le fonctionnera la satisfaction de l d ce mat l doit s qu est permis de le raccorder aux installations de l locale de Le mat doit install en suivant une m accept de raccordement L ne doit pas qu est possible que la conformit aux conditions ci dessus n pas la d du service dans certaines r de mat homologu doivent effectu par un centre d canadien autoris d par le fournisseur La de t peut demander l de d un appareil la suite de r ou de modifications par l ou cause de mauvais fonctionnement sa propre protection l doit s que tous les fils de mise la terre de la source d les lignes et les canalisations d m s y en a sont raccord ensemble Cette pr est particuli importante les r rurales L ne doit pas tenter de faire ces raccordements lui m il doit avoir recours un service d installations ou un selon le cas de charge IC assign a chaque dispositif terminal indique pour toute surcharge le pourcentage de la charge totale qui peut un circuit t boucl utilis par ce dispositif La terminaison du circuit boucl peut constitu de n quelle de dispositifs pourvu que la somme des indices de charge de l des dispositifs ne d pas 100 de charge de ce produit est 2 The Industry Canada label identifies certified equipment This certification means that the equipment meets certain network protective operational and safety requirements Industry Canada does not guarantee the equipment will to the user satisfaction installing this equipment users should ensure that it is permissible to be connected to the facilities of the local telecommunications The equipment must also be installed using an acceptable method of connection The customer should be aware that compliance the above conditions may not prevent degradation of service in some situations to certified equipment should be made by an authorized Canadian maintenance facility designated by the supplier Any repairs alterations made by the user to this equipment or equipment malfunctions may give the telecommunications company cause to request user to disconnect the equipment should ensure for their own protection that the electrical ground connections of the power utility telephone lines and internal metallic pipe system if present are connected together This precaution may be particularly important in rural areas Users should not attempt to make such connections themselves but should contact the appropriate electric inspection or electrician as appropriate Load Number LN assigned to each terminal device denotes the percentage of the total load to be connected to a telephone loop which used by the device to prevent overloading The termination on a loop may consist of any combination of devices subject only to the that the total of the Load Numbers of all the devices does not exceed 100 Load Number of this unit is 2 Warranty Security Controls Ltd warrants that for a period of twelve months from the date of purchase the product shall be free defects in materials and workmanship under normal use and that in fulfilment of any breach of such warranty Digital Controls Ltd shall at its option repair or replace the defective equipment upon return of the equipment to its This warranty applies only to defects in parts and workmanship and not to damage incurred in shipping or or damage due to causes beyond the control of Digital Security Controls Ltd such as lightning excessive mechanical shock water damage or damage arising out of abuse alteration or improper application of the foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other warranties expressed or implied and of all other obligations or liabilities on the part of Digital Security Controls Ltd This contains the entire warranty Digital Security Controls Ltd neither assumes nor authorizes any other person to act on its behalf to modify or to change this warranty nor to assume for it any other warranty or liability this product no event shall Digital Security Controls Ltd be liable for any direct or indirect or consequential damages loss of profits loss of time or any other losses incurred by the buyer in connection with the purchase installation or or failure of this product Digital Security Controls Ltd recommends that the entire system be completely tested on a regular basis despite frequent testing and due to but not limited to criminal tampering or electrical disruption it is possible this product to fail to perform as expected COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Controls Ltd could void your authority to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the FCC Rules These limits designed to provide reasonable protection against harmful interference in a residential installation This equipment generates uses and can radio frequency energy and if not installed and used in accordance with the instructions may cause harmful interference to radio However there is no guarantee that interference will not occur in a particular installation If this equipment does cause harmful to radio or television reception which can be determined by turning the equipment off and on the user is encouraged to try to correct interference by one or more of the following measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Resolve Radio Television Interference Problems This is available from the U S Government Printing Office Washington D C 20402 Stock 004 000 00345 4 INFORMATION equipment complies with Part 68 of the FCC Rules On the side of this equipment is a label that contains among other information the FCC number of this equipment TO TELEPHONE COMPANY Upon request the customer shall notify the telephone company of the particular line to which connection will be made and provide the FCC registration number and the ringer equivalence of the protective circuit Registration Number F53CAN 22830 KX N Equivalence Number 0.2B Jack RJ 31X CONNECTION REQUIREMENTS Except for the telephone company provided ringers all connections to the telephone shall be made through standard plugs and telephone company provided jacks or equivalent in such a manner as to allow for easy disconnection of the terminal equipment Standard jacks shall be so arranged that if the plug connected thereto is withdrawn no to the operation of the equipment at the customer premises which remains connected to the telephone network shall occur by of such withdrawal OF HARM Should terminal equipment or protective circuitry cause harm to the telephone network the telephone company shall practicable notify the customer that temporary disconnection of service may be required however where prior notice is not practicable telephone company may temporarily discontinue service if such action is deemed reasonable in the circumstances In the case of such discontinuance the telephone company shall promptly notify t