DSC ESCORT5580TC v3-0 - User Manual - English - PowerSeries Telephone Interface & Automation Control Module

This manual contains information on limitations regarding product use and function information on the limitations as to liability of the manufacturer W A R N I N G cid 127 3 O COMPLIANCE STATEMENT Changes or modifications not expressly approved by Digital Security Ltd could void your authority to use this equipment equipment generates and uses radio frequency energy and if not installed used properly in strict accordance with the manufacturer instructions may interference to radio and television reception It has been type tested and to comply with the limits for Class B device in accordance with the in Subpart of Part 15 of FCC Rules which are designed to reasonable protection against such interference in any residential However there is no guarantee that interference will not occur in a installation If this equipment does cause interference to television or reception which can be determined by turning the equipment off and on user is encouraged to try to correct the interference by one or more of the measures Re orient the receiving antenna Relocate the alarm control with respect to the receiver Move the alarm control away from the receiver Connect the alarm control into a different outlet so that alarm control receiver are on different circuits necessary the user should consult the dealer or an experienced radio technician for additional suggestions The user may find the booklet prepared by the FCC helpful to Identify and Radio Television Interference Problems This booklet is from the U S Government Printing Office Washington D C Stock 004 000 00345 4 INFORMATION Registration Number F53CAN 22830 KX N Ringer Equivalence 0.2B USOC Jack RJ 31X OF THE EQUIPMENT In the event that this equipment should to operate properly the customer shall disconnect the equipment from the line to determine if it is the customer equipment which is not working or if the problem is with the telephone company network If the problem is this equipment the customer shall discontinue use until it is repaired CONNECTION REQUIREMENTS Except for the telephone provided ringers all connections to the telephone network shall be through standard plugs and telephone company provided jacks or in such a manner as to allow for easy immediate disconnection of the equipment Standard jacks shall be so arranged that if the plug there is withdrawn no interference to the operation of the equipment the customer premises which remains connected to the telephone network shall by reason of such withdrawal OF HARM Should terminal equipment or protective circuitry harm to the telephone network the telephone company shall where notify the customer that temporary disconnection of service may be however where prior notice is not practicable the telephone company temporary discontinue service if such action is deemed reasonable in the In the case of such temporary discontinuance the telephone shall promptly notify the customer and will be given the opportunity to the situation The customer also has the right to bring a complaint to the if he feels the disconnection is not warranted IN TELEPHONE COMPANY EQUIPMENT OR FACILITIES Telephone Company may make changes in its communications facilities operations or procedures where such actions is reasonably required proper in its business Should any such changes render the customer equipment incompatible with the telephone company facilities the shall be given adequate notice to the effect of the modifications to uninterrupted service This equipment should not be used on coin telephone lines to party line service is subject to state tariffs EQUIVALENCE NUMBER REN The REN is useful to determine quantity of devices that you may connect to your telephone line and still have all those devices ring when your telephone number is called In most but not all the sum of the REN of all devices connected to one line should not exceed 5 To be certain of the number of devices that you may connect to your line may want to contact your local telephone company MAINTENANCE FACILITY Security Controls Ltd 160 Washburn St Lockport NY 14094 L de l Canada identifie le mat homologu Cette certifie que le mat est conforme certaines normes de protection et de s des r de t Industrie Canada toutefois pas que le mat fonctionnera la satisfaction de l d ce mat l doit s qu est permis de le aux installations de l locale de t Le mat install en suivant une m accept de raccordement ne doit pas oublier qu est possible que la conformit aux conditions ci dessus n pas la d du service dans certaines r de mat homologu doivent effectu par un centre canadien autoris d par le fournisseur La compagnie de peut demander l de d un appareil la de r ou de modifications effectu par l ou cause de fonctionnement sa propre protection l doit s que tous les fils de mise la de la source d les lignes t et les canalisations m s y en a sont raccord ensemble Cette pr est importante dans les r rurales L ne doit pas tenter de faire ces raccordements il doit avoir recours un service d des installations un selon le cas de charge IC assign a chaque dispositif terminal indique pour surcharge le pourcentage de la charge totale qui peut raccord un t boucl utilis par ce dispositif La terminaison du circuit boucl constitu de n quelle combinaison de dispositifs pourvu que la des indices de charge de l des dispositifs ne d pas 100 de charge de ce produit est 2 The Industry Canada label identifies certified equipment This means that the equipment meets certain telecommunications network operational and safety requirements Industry Canada does not guarantee equipment will operate to the user satisfaction installing this equipment users should ensure that it is permissible to be to the facilities of the local telecommunications company The equipment also be installed using an acceptable method of connection The customer be aware that compliance with the above conditions may not prevent of service in some situations to certified equipment should be made by an authorized Canadian facility designated by the supplier Any repairs or alterations made by user to this equipment or equipment malfunctions may give the company cause to request the user to disconnect the equipment should ensure for their own protection that the electrical ground connections the power utility telephone lines and internal metallic water pipe system if are connected together This precaution may be particularly important in areas Users should not attempt to make such connections themselves but contact the appropriate electric inspection authority or electrician as Load Number LN assigned to each terminal device denotes the percentage the total load to be connected to a telephone loop which is used by the device to overloading The termination on a loop may consist of any combination of subject only to the requirement that the total of the Load Numbers of all devices does not exceed 100 Load Number of this unit is 2 of Contents