DSC NT9005-EU-Installation Manual-v1-0-English

NT9005 EU V1.0 ZONE SECURITY SYSTEM with DLS 3 v1.3 and higher downloading software Programming Guide Digital Security Controls Ltd Canada www dsc com Support 905 760 3036 in Canada 29005276 Rev 003 all comments concerning this to pubs dscltd com This manual contains information on limitations regarding product use and function as well as information on limitations as to liability of the manufacturer Read the entire manual carefully Please Read Carefully to Installers warning contains vital information As the only individual in contact with users it is your responsibility to bring each item in this warning to the of the users of this system Failures system has been carefully designed to be as effective as possible There are however involving fire burglary or other types of emergencies it may not provide protection Any alarm system of any type may be com deliberately or may fail to operate as expected for a variety of reasons but not all of these reasons may be Installation security system must be installed properly in order to provide adequate protec Every installation should be evaluated by a security professional to ensure all access points and areas are covered Locks and latches on windows and must be secure and operate as intended Windows doors walls ceilings and building materials must be of sufficient strength and construction to provide level of protection expected A reevaluation must be done during and after any activity An evaluation by the fire and or police department is highly if this service is available Knowledge system contains security features which were known to be effective at the of manufacture It is possible for persons with criminal intent to develop which reduce the effectiveness of these features It is important that a system be reviewed periodically to ensure that its features remain effec and that it be updated or replaced if it is found that it does not provide the pro expected by Intruders may enter through an unprotected access point circumvent a sensing evade detection by moving through an area of insufficient coverage dis a warning device or interfere with or prevent the proper operation of the Failure units intrusion detectors smoke detectors and many other security require an adequate power supply for proper operation If a device oper from batteries it is possible for the batteries to fail Even if the batteries have failed they must be charged in good condition and installed correctly If a operates only by AC power any interruption however brief will render device inoperative while it does not have power Power interruptions of any are often accompanied by voltage fluctuations which may damage elec equipment such as a security system After a power interruption has immediately conduct a complete system test to ensure that the system as intended of Replaceable Batteries system wireless transmitters have been designed to provide several years of life under normal conditions The expected battery life is a function of the environment usage and type Ambient conditions such as high humidity or low temperatures or large temperature fluctuations may reduce the battery life While each transmitting device has a low battery monitor identifies when the batteries need to be replaced this monitor may fail to as expected Regular testing and maintenance will keep the system in operating condition of Radio Frequency Wireless Devices may not reach the receiver under all circumstances which could include objects placed on or near the radio path or deliberate jamming or other inad radio signal interference Users user may not be able to operate a panic or emergency switch possibly due to or temporary physical disability inability to reach the device in time unfamiliarity with the correct operation It is important that all system users be in the correct operation of the alarm system and that they know how to when the system indicates an alarm Detectors detectors that are a part of this system may not properly alert occupants of fire for a number of reasons some of which follow The smoke detectors may been improperly installed or positioned Smoke may not be able to reach the detectors such as when the fire is in a chimney walls or roofs or on the side of closed doors Smoke detectors may not detect smoke from fires on level of the residence or building fire is different in the amount of smoke produced and the rate of burning detectors cannot sense all types of fires equally well Smoke detectors may provide timely warning of fires caused by carelessness or safety hazards such smoking in bed violent explosions escaping gas improper storage of flamma materials overloaded electrical circuits children playing with matches or Even if the smoke detector operates as intended there may be circum when there is insufficient warning to allow all occupants to escape in time avoid injury or death Detectors detectors can only detect motion within the designated areas as shown in respective installation instructions They cannot discriminate between intrud and intended occupants Motion detectors do not provide volumetric area pro They have multiple beams of detection and motion can only be detected in areas covered by these beams They cannot detect motion which behind walls ceilings floor closed doors glass partitions glass doors or Any type of tampering whether intentional or unintentional such as painting or spraying of any material on the lenses mirrors windows or other part of the detection system will impair its proper operation infrared motion detectors operate by sensing changes in temperature their effectiveness can be reduced when the ambient temperature rises or above body temperature or if there are intentional or unintentional sources heat in or near the detection area Some of these heat sources could be heaters stoves barbeques fireplaces sunlight steam vents lighting and so on Devices devices such as sirens bells horns or strobes may not warn people or someone sleeping if there is an intervening wall or door If warning devices located on a different level of the residence or premise then it is less likely that occupants will be alerted or awakened Audible warning devices may be inter with by other noise sources such as stereos radios televisions air condition or other appliances or passing traffic Audible warning devices however loud not be heard by a hearing impaired person Lines telephone lines are used to transmit alarms they may be out of service or busy certain periods of time Also an intruder may cut the telephone line or defeat operation by more sophisticated means which may be difficult to detect Time may be circumstances when the system will operate as intended yet the will not be protected from the emergency due to their inability to to the warnings in a timely manner If the system is monitored the may not occur in time to protect the occupants or their belongings Failure every effort has been made to make this system as reliable as possible system may fail to function as intended due to the failure of a component Testing problems that would prevent an alarm system from operating as intended be found by regular testing and maintenance The complete system should be weekly and immediately after a break in an attempted break in a fire a an earthquake an accident or any kind of construction activity inside or the premises The testing should include all sensing devices keypads con alarm indicating devices and any other operational devices that are part of system and Insurance of its capabilities an alarm system is not a substitute for property or insurance An alarm system also is not a substitute for property owners rent or other occupants to act prudently to prevent or minimize the harmful effects an emergency situation Warranty Security Controls Ltd warrants the original purchaser that for a of twelve months from the date of purchase the product shall be of defects in materials and workmanship under normal use During warranty period Digital Security Controls Ltd shall at its option or replace any defective product upon return of the product to its at no charge for labour and materials Any replacement and or parts are warranted for the remainder of the original warranty or 90 days whichever is longer The original purchaser must notify Digital Security Controls Ltd in writing