DSC PC1616-PC1832-PC1864 V4-2 User Manual - English - NA

Self Contained Wireless Alarm System Installation Guide This manual contains information on limitations regarding product use and function and on the limitations as to liability of the manufacturer The entire manual should be carefully read of Contents Wiring 1 2 3 Zone Wiring 3 PGM AUX Power Wiring 3 Telephone Line Wiring 3 Battery 4 AC Wiring 4 Device Enrollment 5 Programming 7 Programming 10 programming with PC Link 10 Programming via telephone line 11 Arming 11 Arming 11 11 Commands 11 keys 13 Selection 13 Programming 14 to Program 14 Toggle Options 14 Decimal Hexadecimal Data 14 to Exit Installer Programming 14 Programming 14 Worksheets 15 Programming Worksheets 15 Worksheets 16 Descriptions 33 Troubleshooting 48 A Code Formats Contact ID SIA 50 B Format Options 52 C Approvals Information 54 D False Alarm Reduction Quick Reference Chart 58 E Audio Verification 58 INSTRUCTIONS for SERVICE PERSONNEL When using equipment connected to the TELEPHONE NETWORK there are basic safety that should always be followed Refer to the SAFETY INTRUCTIONS provided with this product them for future reference Instruct the end user regarding the safety precautions that shall be observed when this equipment Installing The Equipment NOT use a sharp or metal object to open the packaging your package includes the following items Guide Manual including the SAFETY INSTRUCTIONS and SAVE These Instructions All WARNINGS AND INSTRUCTIONS specified within these instructions and or on the equipment SCW904x Supply direct plug in Mounting hardware A Suitable Location For The Alarm Controller the following list as a guide to find a suitable place for this equipment it near a telephone socket and a power outlet a place that is free from vibration and shocks the Alarm Controller on a flat stable surface and follow the installation suggestions setting up the equipment near heaters air conditioners ventilators and or refrigerators NOT locate this product where persons may walk on the secondary circuit cable s NOT use extension cords to PLUG IN the power supply of this equipment NOT connect the Alarm Controller to electrical outlets on the same circuit as large appliances NOT select a place that exposes your alarm controller to direct sunlight excessive heat moisture vapors chemicals or dust NOT install this equipment near water e g bath tub wash bowl kitchen laundry sink in a wet basement near swimming pool NOT install this equipment and its accessories in areas where there is a risk of explosion NOT connect this Alarm Controller to electrical outlets controlled by wall switches or automatic timers avoid interference sources Precautions Required During Installation install this EQUIPMENT and or TELEPHONE WIRING during a lightning storm touch uninsulated telephone wires or terminals unless the telephone line has been disconnected at the network interface that cables are positioned so that accidents can not occur Connected cables must NOT be subject to excessive mechanical strain only the power supply supplied with this equipment Use of unauthorized power supplies may cause damage AC socket outlet powering the equipment shall be located near the equipment and shall be easily accessible EQUIPMENT HAS NO MAINS ON OFF SWITCH THE PLUG OF THE DIRECT PLUG IN POWER SUPPLY IS INTENDED TO AS THE DISCONNECTING DEVICE IF THE EQUIPMENT MUST BE QUICKLY DISCONNECTED IT IS IMPERATIVE THAT TO THE MAINS PLUG AND ASSOCIATED MAINS SOCKET OUTLET IS NEVER OBSTRUCTED Contained Wireless Alarm System v1.0 following information is for general guidance only and it is recommended that local fire codes and regulations be consulted when locating installing smoke alarms indicates that all hostile fires in homes generate smoke to a greater or lesser extent Detectable quantities of smoke precede detect levels of heat in most cases Smoke alarms should be installed outside of each sleeping area and on each story of the home recommends that additional smoke alarms beyond those required for minimum protection be installed Additional areas that should be include the basement bedrooms especially where smokers sleep dining rooms furnace and utility rooms and any hallways not by the required units smooth ceilings detectors may be spaced 9.1m 30 feet apart as a guide Other spacing may be required depending on ceiling height air the presence of joists uninsulated ceilings etc Consult CAN ULC S553 or other appropriate national standards for installation not locate smoke detectors at the top of peaked or gabled ceilings dead air space in these locations may prevent smoke detection areas with turbulent air flow such as near doors fans or windows Rapid air movement around the detector may prevent smoke entering the unit not locate detectors in areas of high humidity not locate detectors in areas where the temperature rises above 38oC 100oF or falls below 5oC 41oF detectors should always be located in accordance with detectors shall be installed outside of each separate sleeping area in the immediate vicinity of the bedrooms and on each additional of the family living unit including basements and excluding cra