DSC PC500 - User Manual - English - ClassicSeries 4 Zone Alarm Control Panel

INSTRUCTION 1994 Digital Security Controls Ltd Flint Road Downsview Ontario Canada M3J 2J6 416 665 8460 Fax 416 665 7498 29000528 R3 12 1994 PC5OORK KEYPAD or modifications not expressly approved by Digital Security Controls Ltd could void your COMPLIANCE to use this equipment equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 the FCC Rules These limits are designed to provide reasonable protection against harmful interference in a residential This equipment generates uses and can radiate radio frequency energy and if not installed and used in with the instructions may cause harmful interference to radio communications However there is no that interference will not occur in a particular installation If this equipment does cause harmful interference radio or television reception which can be determined by turning the equipment off and on the user is encouraged try to correct the interference by one or more of the following measures Re orient the receiving antenna Increase the separation between the equipment and receiver Connect the equipment into an outlet on a circuit different from that to which the receiver is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Identify and Resolve Radio Television Problems This booklet is available from the U S Government Printing Office Washington D C Stock 004 000 00345 4 OF CONTENTS INFORMATION Your System Regularly 3 Notice 3 3 OPERATION Your System 4 Your System 4 an Alarm 4 Note About Keypad Commands 4 Zones 5 Alarms 5 Output Command 5 KEYPAD OPTIONS Home Away Zones 7 Arming 7 Arming 7 7 SYSTEM INFORMATION Light 8 Bypassed Zones 8 Alarm Memory 8 Trouble Conditions 8 SYSTEM FEATURES Access Codes 9 Chime On Off 9 the Keypad Sounder Tone and Backlighting 9 AND MAINTENANCE Test 10 Testing 10 10 WARRANTY COMPLIANCE INFORMATION WARRANTY Date INFORMATION Area Delay Delay Cutoff FUNCTIONS Audible Silent Key Security Controls Ltd warrants that for a period of twelve months from the date of purchase the product be free of defect in materials and workmanship under normal use and that in fulfilment of any breach of warranty Digital Security Controls Ltd shall at its option repair or replace the defective equipment upon of the equipment to its repair depot This warranty applies only to defects in parts and workmanship and to damage incurred in shipping or handling or damage due to causes beyond the control of Digital Security Ltd such as lightning excessive voltage mechanical shock water damage or damage arising out abuse alteration or improper application of the equipment foregoing warranty shall apply only to the original buyer and is and shall be in lieu of any and all other whether expressed or implied and of all other obligations or liabilities on the part of Digital Security Ltd This warranty contains the entire warranty Digital Security Controls Ltd neither assumes nor any other person purporting to act on its behalf to modify or to change this warranty nor to assume it any other warranty or liability concerning this product no event shall Digital Security Controls Ltd be liable for any direct indirect or consequential damages loss anticipated profits loss of time or any other losses incurred by the buyer in connection with the purchase or operation or failure of this product Digital Security Controls Ltd recommends that the entire system be completely tested on a regular However despite frequent testing and due to but not limited to criminal tampering or electrical it is possible for this product to fail to perform as expected Key Press the Key to return to the mode adjust the Keypads backlighting press and hold the Key The zone and status lights will be shut off the Keypad will beep as each of the three backlighting levels is shown medium high and off When the level is reached release the all power to the system is shut off each Keypad tone and backlighting will be restored to the factory settings AND MAINTENANCE Test this command will sound the siren and turn ON all the keypad lights for 2 seconds To perform a test enter Testing is recommended that you test your system weekly on the keypad Disarm the system and ensure that the