DSC PC5015-Programming Worksheet-v3-2C-English

Programming Version 3.2C v1.3 and higher the separation between the equipment and receiver Compliance Statement Changes or modifications not expressly approved by Digital Secu Controls Ltd could void your authority to use this equipment equipment has been tested and found to comply with the limits for a Class B device pursuant to Part 15 of the FCC Rules These limits are designed to reasonable protection against harmful interference in a residential installa This equipment generates uses and can radiate radio frequency energy if not installed and used in accordance with the instructions may cause interference to radio communications However there is no guarantee that will not occur in a particular installation If this equipment does cause interference to radio or television reception which can be determined by the equipment off and on the user is encouraged to try to correct the inter by one or more of the following measures Re orient the receiving antenna Connect the equipment into an outlet on a circuit different from that to which the is connected Consult the dealer or an experienced radio television technician for help user may find the following booklet prepared by the FCC useful to Iden and Resolve Radio Television Interference Problems This booklet is available the U S Government Printing Office Washington D C 20402 Stock 004 INFORMATION equipment complies with Part 68 of the FCC Rules On the side of this is a label that contains among other information the FCC regis number of this equipment to Telephone Company The customer shall notify the telephone of the particular line to which the connection will be made and pro the FCC registration number and the ringer equivalence of the protective Registration Number F53CAN 34330 AL E Equivalence Number 0.1B Jack RJ 31X Connection Requirements Except for the telephone company pro ringers all connections to the telephone network shall be made through plugs and telephone company provided jacks or equivalent in such a Canada Statement L de l Canada identifie le mat homologu Cette certifie que le mat est conforme certaines normes de protection et de s des r de t Industrie Canada toutefois pas que le mat fonctionnera la satisfaction de l d ce mat l doit s qu est permis de le rac aux installations de l locale de t Le mat install en suivant une m accept de raccordement ne doit pas oublier qu est possible que la conformit aux conditions ci dessus n pas la d du service dans certaines sit r de mat homologu doivent effectu par un centre canadien autoris d par le fournisseur La compagnie de t peut demander l de d un appareil la de r ou de modifications effectu par l ou cause de fonctionnement sa propre protection l doit s que tous les fils de mise la de la source d les lignes t et les canalisa d m s y en a sont raccord ensemble Cette pr est importante dans les r rurales L ne doit pas tenter de faire ces raccordements lui il doit avoir recours un service d des installations ou un selon le cas de charge IC assign a chaque dispositif terminal indique pour surcharge le pourcentage de la charge totale qui peut raccord un t boucl utilis par ce dispositif La terminaison du circuit boucl constitu de n quelle combinaison de dispositifs pourvu que la des indices de charge de l des dispositifs ne d pas 100 de charge de ce produit est 0.1B as to allow for easy immediate disconnection of the terminal equipment jacks shall be so arranged that if the plug connected thereto is with no interference to the operation of the equipment at the customer pre which remains connected to the telephone network shall occur by reason of withdrawal of Harm Should terminal equipment or protective circuitry cause harm the telephone network the telephone company shall where practicable notify customer that temporary disconnection of service may be required however prior notice is not practicable the telephone company may temporarily dis service if such action is deemed reasonable in the circumstances In the of such temporary discontinuance the telephone company shall promptly the customer and will be given the opportunity to correct the situation Telephone Company Information The security control panel must be connected to the telephone line with a USOC RJ 31X telephone jack FCC prohibits customer provided terminal equipment be connected to party or to be used in conjunction with coin telephone service Interconnect rules vary from state to state in Telephone Company Equipment or Facilities The telephone com may make changes in its communications facilities equipment operations procedures where such actions are reasonably required and proper in its busi Should any such changes render the customer terminal equipment incom with the telephone company facilities the customer shall be given notice to the effect modifications to maintain uninterrupted service Equivalence Number REN The REN is useful to determine the quantity devices that you may connect to your telephone line and still have all of those ring when your telephone number is called In most but not all areas the of the RENs of all devices connected to one line should not exceed five 5.0 be certain of the number of devices that you may connect to your line you may to contact your local telephone company Maintenance Facility If you experience trouble with this telephone please contact the facility indicated below for information on obtaining or repairs The telephone company may ask that you disconnect this from the network until the problem has been corrected or until you are that the equipment is not malfunctioning Security Controls Ltd 160 Washburn St Lockport NY 14094 The Industry Canada label identifies certified equipment This certifica means that the equipment meets certain telecommunications network protec operational and safety requirements Industry Canada does not guarantee the will operate to the user satisfaction installing this equipment users should ensure that it is permissible to be to the facilities of the local telecommunications company The equip must also be installed using an acceptable method of connection The cus should be aware that compliance with the above conditions may not degradation of service in some situations to certified equipment should be made by an authorized Canadian main facility designated by the supplier Any repairs or alterations made by the to this equipment or equipment malfunctions may give the telecommunica company cause to request the user to disconnect the equipment should ensure for their own protection that the electrical ground connections the power utility telephone lines and internal metallic water pipe system if are connected together This precaution may be particularly important in areas Users should not attempt to make such connections themselves but contact the appropriate electric inspection authority or electrician as Load Number LN assigned to each terminal device denotes the percentage the total load to be connected to a telephone loop which is used by the device prevent overloading The termination on a loop may consist of any combination devices subject only to the requirement that the total of the Load Numbers o