DSC PC5964E - Audio Station - Installation Instructions - Eng - R001

PC5964E Audio Station Installation Instructions instruction sheet shall be used in conjunction with the associated Audio Verification Module Installation Manual part 29009400 Temperature Range 10 to 55 14 to 131 UL ULC 0 to 49 up to 93 RH non condensing Rating 7.6 8.6 VDC 30mA min 190mA max Distance all audio stations 152m 500ft 160mm x 117mm x 12mm 6.3 x 4.6 x 0.5 245g Range 7.62m 25ft Audio Verification Modules HSM2955 HSM2955R Instructions required remove the front cover from the backplate as follows a Insert a small slotted screwdriver in one of the slots indicated in Fig 1 b Gently pry the cover from the backplate c Repeat this operation on the remaining slot Lift cover free of backplate 1 Repeat steps 1 and 2 for this side Insert Push down to open Determine the desired location and mounting method A B C or D surface mount a For A B or C Fig 2 mounting methods position the backplate over the electrical box ensuring free access to wiring Then the screw locations indicated for the chosen mounting method For D mounting surface mount remove the wiring access flange on the side of the backplate Position the backplate in the location then mark the screw locations at the 4 corners of the backplate DSC recommends the use of wall anchors when mounting directly onto a wall Flange 2 Single Double Gang Box Octagonal Box European Wall Ceiling Box Route wiring as required see Figure 3 Secure backplate to wall using the appropriate hardware Wire unit in accordance with the associated Audio Verification Module instructions Place front cover over backplate Gently press until cover locks in place with an audible click Power up system then verify operation BLK YEL GRN Controller 3 GND AIN BLK YEL GRN AUX COM TAM M1 M2 M3 M4 1 SPK 2 GND AIN TIP R 1 T 1 EGND Com Com Com Com Spkr Spkr Spkr Spkr Any combination of audio stations can be used as long as the HSM2955 AUX output current rating is not exceeded IC STATEMENTS Changes or modifications not expressly approved by Digital Security Controls could void your authority to use this equipment equipment generates and uses radio frequency energy and if not installed and used properly in strict accordance with the manufac instructions may cause interference to radio and television reception It has been type tested and found to comply with the limits Class B device in accordance with the specifications in Subpart of Part 15 of FCC Rules which are designed to provide reasonable against such interference in any residential installation However there is no guarantee that interference will not occur in a par installation If this equipment does cause interference to television or radio reception which can be determined by turning the off and on the user is encouraged to try to correct the interference by one or more of the following measures i Re orient the antenna ii increase the separation between the equipment and receiver iii connect the equipment into an outlet on a circuit from that to which the receiver is connected If necessary the user should consult the dealer or an experienced radio television for additional suggestions The user may find the following booklet prepared by the FCC helpful to Identify and Resolve Interference Problems This booklet is available from the U S Government Printing Office Washington D C 20402 004 000 00345 4 ICES 3 B NMB 3 B Tyco Security Products All rights reserved 1 800 387 3630 Canada US 905 760 3000