DSC Power432 - Default panel 432-864 rev 005

Reset Panel to Factory Default Power432 PC1555 Power632 PC5010 Power832 PC5020 Power864 PowerSeries panel can be defaulted provided installer lockout is not enabled There are ways to default the panel a software default and a hardware default Default Main Panel Hardwire factory default the main control panel perform the following 1 Remove AC and battery from the panel 2 Remove all wires from the Zone 1 and PGM1 terminals 3 With a piece of wire short the Zone 1 terminal to the PGM1 terminal 4 Apply AC power to the main panel 5 Zone light 1 will turn ON when the default is complete approx 30 seconds 6 Remove AC power from the panel 7 Reconnect all original wiring and power up the control panel normally Only the main panel will default All modules will not be affected Default Main Panel Software factory default the main control panel perform the following 8 Installer Code 999 Installer Code 999 again Installer Programming Section Factory Default panel will take a few seconds to perform the default When the keypad is again operational default is complete Only the main panel will default All modules will not be affected